Jump to content
SAU Community

Recommended Posts

  • Replies 189
  • Created
  • Last Reply

Top Posters In This Topic

I think it was the rear right that got wrecked most on my car, i just thought it was the course layout though. I did 2 texis on 1 set of rubber, the only reason i managed to kill it then was because i dual entered my xr6 and my mate did even more skids than I did.

Not long to go now.

I'm bringing my Silvia up instead of a RB powered car. Hopefully it won't break down but reliability has been pretty poor :ermm:.

How much track time do you normally have at one of these as I am only planning to bring 1 pair of brand newies....

I am pretty sure I may have half worn shite rubber on 33 rims you can also take if you want... The rubber is half gone anyway... How much tyre you use depends on how many skids you do..... lol

It says passengers must wear wrist to neck/ankle clothing with enclosed shoes and approved helmet, do drivers have to wear this too? Only thought of this today because i saw sweating while driving in shorts and a shirt :(

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Brooooo Please send ABS control unit schematic Please! R33 gts25t ABS (Its two plug ecu, black and white) wire colors possible? [email protected]
    • Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
    • Hi. Sry iam not a mechanic and iam not at the car atm so i dont know 100% but they told they measure those and even try to change those. AFM they have two. Coils are new a they have my old one too. Plugs too. ECU...we have 25 NEO stock and Nistune 25 NEO.   But i dont know if any one those could be the problem and why/if/what can cause this, Only thing they did not check is fuel...but that walbro 255 is new(like 1,5 years)... That fuel pressure gauge idk...but i let them know Any suggestions?   EDIT: how can they know if it is like you say he ECU pull power when it reaches a specific boost level that is too high? Tha car has boost controler
    • Can you clarify what you mean by boost cut, do you mean it misfires both when under load (driving) and when stationary and out of gear? Or does the ECU pull power when it reaches a specific boost level that is too high (boost control issue)? Does it occur at idle with no throttle? When you say "the ECU is OK", what ECU is it and why do you think it is OK? Have you used the NEO ECU, and if so do you have a MAP sensor attached? Same for the AFM, why do you think it is OK? Do you have any way to put a fuel pressure gauge on it (even just a mechanical one between the fuel filter and fuel rail)?
×
×
  • Create New...