Jump to content
SAU Community

Recommended Posts

Sorry slinky, no pro db meters available, just Dyno and BBQ

Look forward to seeing everyone out, we've cleared out the cars for undercover standing room, and afternoon weather is looking good.

  • Replies 45
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

okay thanks for the reply

is it just being promoted through the Skyline forum?? Just he doesn't wanna be the only non Skyline there

its also promoted on the silvia forums. I'll be there in a 350Z...

thx to sam for organising the event

was good we didnt get much rain

was pretty happy with what the car pulls

so what did your new car end up pulling? keen to check your new beast out :P

40 cars, Sausages, Drinks = $2000+ raised for Australian Cancer Research Foundation

Thanks everyone who helped and everyone who put their cars on.

Thanks for the night Sam. Good turnout,

Next time round i'l make sure i raise the car a little higher for you haha, However i didnt particularly mind taking home the award for lowest car of the night! =)

Hi Sam, Went back to chasers to get my AFR fixed and he re-dynoed my car and said they were fine, and he said that your dyno is broken.

Cheers

lol, wtf?

if i recall it was running far too lean...

Paul showed me the dyno sheet.. cars running beautifully.. its not running lean at all..

Its either Sam's dyno is wrong, or chasers and judging by pauls reaction, its sams..

Yet you post this 2 days ago?

http://www.skylinesaustralia.com/forums/En...-D-t342395.html

Something isn't adding up, flashing like that = detonation = running mega lean.

My engine light was flashing BEFORE my chasers tune, (when it was tuned by RACE PACE by BEN)

Heres a message from the old owner of the car aswell..

VERY IMPORTANT - ONLY USE 98 RON fuel (Shell VPower / Synergy 8000 / etc), otherwise the engine may ping/detonate. When you install a Power FC the check engine light on the dash (yellow light, top right) becomes like a knock sensor. If you ever see this flash at you need to back off on the throttle. You can still drive the car OK but just don't put your foot down. This basically never happens but might if you fill up with 95RON, have a bad batch of fuel and/or it's a really hot day (40 degrees plus). Just take it easy on those days.

-

Its happened about 3 times in the 2 months i've owned it.. So not really sure what the problem is..

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
    • Yeah mate, never miss it.
    • Any going to watch World Time Attack at SMSP this year?
    • Appreciate the correction on the "ground", that will make a huge difference to looking at this. That makes complete sense about AF70/AF71 which is what I had come down to being the issue, one of these. I'll have another look in the ignition wiring when I get a chance next week. I'll also make up a jumper wire for running that AF73 test.  ECU is fine, relay itself is fine, pump harness is fine and the pump itself is fine. I am going to upgrade the Walbro 255 anyway with a DW300 I have since I need to replace the fuel sender and I'm going to upgrade the FPR with my chasebays kit ready for new plenum/injectors/dbw, but I'll get this working first. That's why this is so frustrating. 
×
×
  • Create New...