Jump to content
SAU Community

Recommended Posts

Hi all,

I just fitted some mods on my R34GTR..-5,injectors,aftermarket fuel reg and pump, full exhaust,ebc

Its just needs to be fitted and tuned with a power f/c..

Its it safe to drive the car hard even though its not tuned yet.

and at the moment still running on standard ecu and stock boost with these mods?

Link to comment
https://www.sau.com.au/forums/topic/345450-is-it-safe-to-drive-the-car-hard/
Share on other sites

  • Replies 61
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

bahahahaha... not helpful but i like the comment "I'll be honest ive driven it hard a few times to see how it goes.."

the amount of dead gtr's ive seen cause of this same sentiment cracks me up.

PS its idling smoother cause its way richer, dont drive it too much as you will start to wash down the bores. usually we recomend only driving to the tuners with that sort of injector upgrade.

440 vs 600... umm yeah they arealmost 50% bigger...

-5s will do 380-400rwkw, so 600 were a bad choice.

you'd have been better off with 700's and the factory fuel red IMO.

would have been cheaper as well.

What the f**k is with all these knobs using the word "Hater"?!

I see it from every new member.

"Stop being a hater" "Your just a hater"

Dead set, you aint gangsta because you say the word hater, you just sound like a 16 year old pimple faced white kid.

Edited by PM-R33

Here we go....

I wasn't "giving shit". My comment to you was based on the fact that you "claim" to have fitted larger turbos and a larger fuel system onto your vehicle.

First of all I know straight away that you personally didn't fit them yourself but would have had to pay some one to do so. My reasoning for this claim is due to the fact if you had the ability to do such a large job as fit aftermarket turbochargers onto a RB26 engine you wouldn't be stupid enough to think it may be safe to drive a vehicle hard on a stock ECU with larger injectors and turbos designed for x amount of airflow and y amount of fuel. Also you have chosen to get an aftermarket fuel pressure regulator fitted. Clearly if you had picked the right sized injectors in the first place you wouldn't need to be trying to bump up the rail pressure to squeeze more power out of the smaller injectors. Once again strengthening my claim and opinion on you.

This summed up my comment of you not deserving a nice car such as an R34 GTR, perhaps something along the lines of a Daewoo Lanos would be more up your ally.

Please reply back to me with some thing unintelligent like "f**k you" or something similar to once again strenghthen my claim and to get this thread locked.

Ask a stupid question; get treated line an idiot.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...