Jump to content
SAU Community

Recommended Posts

sorry for my ranting earlier, i was rather pissed off and the tuner will never answer their phone and i have some other issues so i took it out on here so SORRY EVERYONE.

DSC_0003.jpg

edit, its running a high pressure actuator, that run is without a boost control as far as i know.

Edited by lilcrash

R35 GTR seats fitted! Sitting much lower than my factory seats! Need to raise the passenger seat a touch. Loving how factory they look.

Boost controller/emanage in and tuned. Having the same issue as lillcrash. Spiking at 18psi and dropping to 14psi. Need a tougher spring. Car drives much much better though. Less lag, much more mid and a bit more up top.

R35 GTR seats fitted! Sitting much lower than my factory seats! Need to raise the passenger seat a touch. Loving how factory they look.

Boost controller/emanage in and tuned. Having the same issue as lillcrash. Spiking at 18psi and dropping to 14psi. Need a tougher spring. Car drives much much better though. Less lag, much more mid and a bit more up top.

lol..... :whistling: you do need to raise that passenger seat a tad.. felt l I was sitting on the floor.. also never had trouble seeing over the dash before.. lol

Yes, it does feel good.

yeah, horrible boost drop off there...try and get that fixed before being too concerned.

I'd start by running the car again with no exhaust, and see what the result is. Also, have a look at the intake under the bonnet when it is at full boost for anything sucking shut, stock rubber parts in particular

Finished putting my freshly painted d pillar panels and mirrors on, removed the factory rust from behind the mirrors. More rust than I expected but minor compared to some I've seen

yeah, horrible boost drop off there...try and get that fixed before being too concerned.

I'd start by running the car again with no exhaust, and see what the result is. Also, have a look at the intake under the bonnet when it is at full boost for anything sucking shut, stock rubber parts in particular

If the exhaust Is the restriction it will always be there. It's too loud without an exhaust. Mayb the k&n is too restrctive

installed my shift kit today. definite improvement! also fixed the leak in the trans cooler pipework

helped craig swap his gearbox!

and managed to buy a nismo ecu on yahoo.

not bad for a days work!

installed my shift kit today. definite improvement! also fixed the leak in the trans cooler pipework

helped craig swap his gearbox!

and managed to buy a nismo ecu on yahoo.

not bad for a days work!

Lol, how good is the shift kit?:thumbsup:

More awesome? You already had one, right?

Took mine for a burn up the old pacific hwy today with a mate in a 180SX.

Glad I moved the fnt sway bar to the maximum slot, much better handling. Was fun driving a SR20 for a bit (would make great track/weekend hack), but swapping cars, I defiantly saw 15 years of improvements/refinements/abuse

Bought a few car detailing things and ordered a transcooler too!

Winning!

Edited by PN-Mad

one item of awesome will be up for sale yes

as for the shift kit, for a few bits of metal and a few springs, its a massive improvement lol

Dibs! Send me a pm if/when its for sale!

Took mine for a burn up the old pacific hwy today with a mate in a 180SX.

Glad I moved the fnt sway bar to the maximum slot, much better handling. Was fun driving a SR20 for a bit (would make great track/weekend hack), but swapping cars, I defiantly saw 15 years of improvements/refinements/abuse

Bought a few car detailing things and ordered a transcooler too!

Winning!

Which trans cooler did you go for?

one item of awesome will be up for sale yes

as for the shift kit, for a few bits of metal and a few springs, its a massive improvement lol

Love the fact that now you are only apportioning "Awesome" to worthy cars/owners...happy.gif

Edit - PWR 280x150 just getting it ordered from repco... they can order in any PWR stuff. Should be good enough, plus I don't fleabay.

Edited by PN-Mad

Love the fact that now you are only apportioning "Awesome" to worthy cars/owners...happy.gif

Edit - PWR 280x150 just getting it ordered from repco... they can order in any PWR stuff. Should be good enough, plus I don't fleabay.

If he keeps buying all the 'awesome' before anyone else gets it, then he can be the gatekeeper! :worship:

Nice one on the trans cooler. Didn't think of that, was going to order B&M online. I'll go see them tomorrow. Does yours have a thermostat?

If he keeps buying all the 'awesome' before anyone else gets it, then he can be the gatekeeper! :worship:

Nice one on the trans cooler. Didn't think of that, was going to order B&M online. I'll go see them tomorrow. Does yours have a thermostat?

Lol...

It doesn't have a internal thermostat- I'll be getting one off Jetwreck that goes in line and does the job. PM him if interested...

Dibs! Send me a pm if/when its for sale!

there will be a post lol

maybe ill ebay it. not sure yet!

is it just me or after the shift kit install, the transmission appears to 'slip' less even on take off? im guessing this may assist with fuel economy

That cooler is plenty big enough, I like the look of those little thermostats; full flow in bypass.

I'm a little dubious about the way the b&m coolers use oil viscosity as a measure of temp for the bypass.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I am yet to see anyone ever regret a quaife or helical. ...other than drifting/skidpan duties. I kind of want to upgrade my factory helical with a Quaife (but really it's not ultimately that different, and is a MASSIVE UNDERTAKING), that's how good the hype is about them, that I want to try them 'just to see'  
    • D2 and Ksport are essentially the same thing and basically just generic Taiwanese manufacture. Better than ChinaBay crap, but... not top shelf. Öhlins have got to be some of the best dampers around, so likely to be a good option. It's going to get to the point though where I suggest you buy from Oz. We have at least 2x excellent options here. If I were you though, I'd be talking to KW about doing something for the R33. There's bugger all difference between that and the 32. In GTR land, anyway.
    • KW only offers a set for the R32 GTR. Popular options are D2 racing, Ksport or Öhlins. I have a D2 Racing coilover set, though I don't know for sure which one.
    • Well, the good news is you have more than one very good option for new coilovers in and around your country. Worth the drive over to KW to talk about GTR stuff.
    • Fair enough, I am in no way a tire expert so I'm not familiar with all the terms and conditions. I'll definitely note down the AD09 to potentially try in the future. Rain is not too big of a concern for now as I will probably only drive in the rain when I have to. And considering I still lack experience driving the GTR I'd more than likely take it easy too. I have coilovers in the car but as I barely got to drive so far I never bothered to even check if they are adjustable haha. The suspension is almost entirely old and worn as well so I suppose when I eventually fix that in the future that would make a huge difference.
×
×
  • Create New...