Jump to content
SAU Community

Recommended Posts

Today i was cleaning out the boot of my r32...

and down the sides i noticed some dirt (after i pulled all the boot lining out,) and found a pair of jap sun glasses! score!!

but what i really want to know is..

there is all these scres and stuff and i noticed theres something attached to them

so i was wondering.. what electonic stuff is ment to be in the boot (on the passangers side)

Link to comment
https://www.sau.com.au/forums/topic/34940-whats-in-your-boot/
Share on other sites

The 2nd one is for the fuel pump and fuel gauge sender in the fuel tank. The cover plate gives you access to the top of the fuel tank to remove the pump & sender unit.

If you can see the ground through that one, then someone has stolen your fuel tank.

lol yeh as blind elk says thats ur fuel pump in there. if u unscrew and lift that out thats ur fuel pump. and then yeh the wiring n shit for it is connected to the top.

then the other one is where ur motor and shit are for ur power aerial which is on the outside of the car just there, as people have said. :)

in my old S13 180, it had some kind of rattley sound from the boot, i spent ages trying to fix the jack in a solid place, it still did it. stuck my arm down the side of the car in the dark and felt round (bit aprehensive to do that realy haha), and i found ... a japanese golf ball! i now it was jap coz it had jap writing on it. hehe

For sure the bottom pic is the fuel pump. The middle one would be the rubber seal. For my car, I don't hv any antenna and speaker hole at the rear at all. I know all r32 use to hv antenna in the front wind screen.

Abo Bob - You have me a bit lost on that one.. im not sure where the problem is?

Also for everyone, in that top pic where it says "Glasses" i noticed there is a metal bracket screwed in on an angel, does anyone know what this is for.. i can post pics if your not sure what i mean?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...