Jump to content
SAU Community

Recommended Posts

  • Replies 157
  • Created
  • Last Reply

Top Posters In This Topic

One thing I'll add for those out there that have only done a few track days. Get into a car as a passenger with one of the experienced guys. It takes a few laps to get over the sensation of not being in control, but you learn heaps!

You learn a lot by doing but if you are a keen observer, you can learn a lot that way too.

hey guys, last minute entry.

ive emailed my form, im with NAB but im not sure if the money will clear by tonight, can i pay on the day??

ill also need a license purchased on the day.

estimated avival time is 730 to get everything sorted.

If anyone would like some pointers, grab me for a session - I'll be around the dummy grid or flag point somewhere.

i'd like to grab you for a session........oh wait.....

on second thoughts, the boat did need something to chase :P

if you ppl lower your standards enough to jump in a pissy little 2L then i'll cling wrap my passenger seat in case you have any accidents ;)

hey guys, last minute entry.

ive emailed my form, im with NAB but im not sure if the money will clear by tonight, can i pay on the day??

ill also need a license purchased on the day.

estimated avival time is 730 to get everything sorted.

incase you werent sure paying on the day is fine..




  • Similar Content

  • Latest Posts

    • For fuelling the Haltechs have O2WB fuel controllers. Very useful for helping tuning VE and correcting for *small* mistakes. Of course if your injector/cam/trigger/sensor data is just wrong (or for a GTT which is not a GT) then you will get impossible reactions to things. I am sure you know this already but the reason people don't typically put haltechs (or any Aftermarket ECU) on GT's is because there's practically no real gains to be had - So this knowledge won't be commonplace.
    • Can someone tell me if the cracks seen in the rear sway bar bushings in these photo's is unacceptable from a roadworthy point of view?  
    • Shouldn't need a "base map" for anything other than guidance to ignition tuning. You just need the engine capacity right, the injector size right, and something, almost anything, for a VE map. On an NA engine, fuelling is almost completely a function of load signal & rpm. It should run and drive with a completely flat fuel map. It will be too lean under load, but that's easily fixed. We used to tune all ECUs without any base map. There were no such things (until someone had tuned a near stock engine on one, and then they had a "base map".
    • What did you actually buy/how much did it cost? When I got mine in like.. 2017...? 2019? the aim was to run Torque for gauges via ODB2 and things like Track Addict/Laptimers/Dashcam/Reversecam/Spotify etc. Mine never broke, but I wonder if you've got the same needs (it sounds like it). Cause I liked the idea of being able to do anything with it. That said, yours also cost 3x the cost of what I spent so... food for thought.  
    • For me there is a massive difference in manufacturer or big brand crippled android (Sony, Kenwood etc) vs the sort of thing I've installed here, which is basically just a tablet in DIN form factor with open Android, and the other model of course is mirroring - Android Auto/Carplay. I hate the locked down manufacturer and AA options where they decide what apps I'm allowed to install, including the Launcher but also importantly things like Ecutek (for this car) or Real Dash (Stagea) are not supported. Plus those crippled versions tend to be slower due to both overheads and lower spec hardware. On the other hand, when this breaks I'll likely be in trouble for support....but how is that different to owning an Infiniti anyway
×
×
  • Create New...