Jump to content
SAU Community

Recommended Posts

Hi

I am about to have a full exhaust system done on my series 2, RS Four S.

Not sure at this point wether to get twin dump pipe or just a bellmouth.

I will also be getting a Blitz LM return flow intercooler installed and was wondering if I will need to have the car tuned with aftermarket ecu piggyback or maybe Nistune board.

Or will the car run fine with the standard ecu ?

Any help would be great thanx

post-93563-0-21462800-1336787141_thumb.jpg

Since you have a S2 you would benefit from getting a Nistune fitted and tuned. The car will run on the stock ecu but from stock they all run very rich and a tune will benefit economy and/or performance and help your engine live longer.

Do the exhaust and the intercooler first if you want and get the Nistune as soon as you can.

Yes if you can source an R34 GT-t PFC and run 3.7v to pin 51 on the ecu to get around traction control you can use a PFC.

If you just gut your existing cat you get the same thing for free. More power noise very slightly increased.

nistune is about $350 without the software (off the top of my head)

+ cost of tune

pfc is $1000+

+cost of tune

with an exhaust and no tune on 7psi my rs4s was making 135awkw

10psi and a nistune + tune will get you near 200awkw

a guy i know with another rs4s said the tune was the most noticable mod he has done so far

also, the cost of tuning a nistune would only be a little more than a piggyback but you will get much better results

I already have Greddy power extreme exhaust, blitz intercooler, Greddy oil catch tank, JJR bellmouth dump pipe all awaiting to be installed. I will also be getting Splitfire coil pack and from what your all saying is I need Nistune board fitted, boost controller and then a tune. What kind of power should I then expect to see ?

Hey mate, perhaps jump into the Forced Induction performance thread and have a flick through the recent pages of the RB25 dyno results. That will give you something to go off, and then you can see what to expect. With the stock turbo, people don't push too hard.

Have you bothered to read anything in your own thread? I swear this has been asked and/or answered already more than once.

And right there is the reason a lot of people don't get on these forums cause there's always someone who has to show some infant ism.

I am merely asking to clarify so as not to get told some bs from a workshop. After all isn't that what this is here for. C'mon

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...