Jump to content
SAU Community

Recommended Posts

Hi, I've got a series 2 C34 Stagea that the wife drives, when we went to clean the car couple of days ago we noticed the carpet in the front drivers side footwell was damp and the underside of the floor mats were wet. Not wanting the carpets to go moldy I've pulled out the drivers seat pulled up the carpet and noticed that there was alot of water collected in the front and rear footwell and the white foam was soaked. I've soaked up as much water with towels as I can and am currently drying the foam and carpets out with a hair dryer.

Does anyone know a possible scorce of the water? The wife usually has the air con climate control on all the time and I originally thought it could be condensation from the rear foot a/c duct but it seems like alot of water for that

Any help or similar experience stories and solutions or fixes would be greatly appreciated cause I don't way it collecting again

Link to comment
https://www.sau.com.au/forums/topic/409399-water-in-foot-well-c34/
Share on other sites

It would definitely be worth checking that the drain from the aircon condenser hasn't fallen off, or isn't kinked or blocked; this could result in all the condensate water from the aircon running down the inside of the firewall.

Water from your heater core should be green; this is the colour of the coolant you should have in the cooling system.

:wacko: I have the same problem. Pretty sure its not the heater core as the coolant level is not going down. Most of the water comes down the LH side - must find the aircond drain and maybe the drain from the sun roof but it could be something else altogether

yeah exactly, the front sunroof drain is a plastic pipe down the a pillar to the front wheel well somewhere, the rear drain down the C pillar to the rear wheel well.

mine leaks from the front sunroof drain into the passenger footwell, with all that lovely sound deadening it can stay damp for ages unless you dry it out.

but since I've never worked out where mine is blocked, I just don't park it nose downwards when it rains :)

Ok so if the sunroofs drain down the passenger side pillar why would the water be in the drivers side foot well? It seemed to of collected most near the trams tunnel near the rear a/c plastic duct thing (where the hump is, left side of the drivers side footwell)

you've got me there, no way for water to get over the transmission tunnel. maybe there are 2 drains, one on either side. mine always leaks passenger side.

also ac drain is on the passenger side.

heater core is above the trans tunnel so it could leak either side, but coolant is a very specific colour and smell, you wouldn't confuse it for water (unless you are running water in the radiator of course)

Has it been raining much in your area recently?? I had the same thing with my car a while back. It had been raining for weeks and i noticed 1 day that the carpet was damp. The water was getting in somewhere (unfortunately i didnt find it), but as soon as the rain stopped it dried out. No matter how much i ran the hose over the car, i never found where it was getting in.

I have just replaced the heater core in a C34,with one from an R33, the existing core was maked as Laurel. The core had a hole in it I think due to no green stuff in the water.

It was leaking into the drivers footwell through the ducting, with less water in the passenger footwell.

As it was the first time I have had to do this, I removed the entire dash pad, centre console, loosened the steering column and everthing to get to it, after doing it I think I would be able remove the core without taking the entire dash out.

The hassel was removing the passenger air bag to get at the fan out of the way to access the core. It is a mission even for me who takes cars to bits on a regular basis.

There three units that make up the heater setup, Ducting director, fan assembly and heater core assembly.

Took a day to get out, replace and back in.

I suppose it's possible just to get a radiator place to pressure test the heater core and see if that's the cause of the leak

Well yes you'd just be pressure testing the whole system with the heater full on and looking for the leaks! I got a heater core for my last Stagea (I'm on my third C34!) brand new from the local radiator shop - once they see it they can match it up - they are common with a number of other cars.

Checked the carpet again today and the water is back :(, I might have to try to bypass the heater core dry it out and see if it comes back again. Is there a guide to changing a heater core or do you just keep taking stuff out until you can get to it, the cars got a xanavi climate control unit, will it be any problems if I bypass the core?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hey Dave, welcome aboard! Good to see another soon-to-be Stagea owner here. The wagons are awesome — plenty of space, still got that Skyline DNA, and loads of potential if you’re into mods. Definitely post up pics when you get it, everyone here loves seeing new builds. What model/year are you looking at?
    • See if you can thermal epoxy a heatsink or two onto it?
    • The other problem was one of those "oh shit we are going to die moments". Basically the high spec Q50s have a full electric steering rack, and the povo ones had a regular hydraulic rack with an electric pump.  So couple of laps into session 5 as I came into turn 2 (big run off now, happily), the dash turned into a christmas tree and the steering became super heavy and I went well off. I assumed it was a tyre failure so limped to the pits, but everything was OK. But....the master warning light was still on so I checked the DTCs and saw – C13E6 “Heat Protection”. Yes, that bloody steering rack computer sitting where the oil cooler should be has its own sensors and error logic, and decided I was using the steering wheel too much. I really appreciated the helpful information in the manual (my bold) POSSIBLE CAUSE • Continuing the overloading steering (Sports driving in the circuit etc,) “DATA MONITOR” >> “C/M TEMPERATURE”. The rise of steering force motor internal temperature caused the protection function to operate. This is not a system malfunction. INSPECTION END So, basically the electric motor in the steering rack got to 150c, and it decided to shut down without warning for my safety. Didn't feel safe. Short term I'll see if I can duct some air to that motor (the engine bay is sealed pretty tight). Long term, depending on how often this happens, I'll look into swapping the povo spec electric/hydraulic rack in. While the rack should be fine the power supply to the pump will be a pain and might be best to deal with it when I add a PDM.
    • And finally, 2 problems I really need to sort.  Firstly as Matt said the auto trans is not happy as it gets hot - I couldn't log the temps but the gauge showed 90o. On the first day I took it out back in Feb, because the coolant was getting hot I never got to any auto trans issues; but on this day by late session 3 and then really clearly in 4 and 5 as it got hotter it just would not shift up. You can hear the issue really clearly at 12:55 and 16:20 on the vid. So the good news is, literally this week Ecutek finally released tuning for the jatco 7 speed. I'll have a chat to Racebox and see what they can do electrically to keep it cooler and to get the gears, if anything. That will likely take some R&D and can only really happen on track as it never gets even warm with road use. I've also picked up some eye wateringly expensive Redline D6 ATF to try, it had the highest viscosity I could find at 100o so we will see if that helps (just waiting for some oil pan gaskets so I can change it properly). If neither of those work I need to remove the coolant/trans interwarmer and the radiator cooler and go to an external cooler....somewhere.....(goodbye washer reservoir?), and if that fails give up on this mad idea and wait for Nissan to release the manual 400R
    • So, what else.... Power. I don't know what it is making because I haven't done a post tune dyno run yet; I will when I get a chance. It was 240rwkw dead stock. Conclusion from the day....it does not need a single kw more until I sort some other stuff. It comes on so hard that I could hear the twin N1 turbos on the R32 crying, and I just can't use what it has around a tight track with the current setup. Brakes. They are perfect. Hit them hard all day and they never felt like having an issue; you can see in the video we were making ground on much lighter cars on better tyres under brakes. They are standard (red sport) calipers, standard size discs in DBA5000 2 piece, Winmax pads and Motul RBF600 fluid, all from Matty at Racebrakes Sydney. Keeping in mind the car is more powerful than my R32 and weighs 1780, he clearly knows his shit. Suspension. This is one of the first areas I need to change. It has electronically controlled dampers from factory, but everything is just way too soft for track work even on the hardest setting (it is nice when hustling on country roads though). In particular it rolls into oversteer mid corner and pitches too much under hard braking so it becomes unstable eg in the turn 1 kink I need to brake early, turn through the kink then brake again so I don't pirouette like an AE86. I need to get some decent shocks with matched springs and sway bars ASAP, even if it is just a v1 setup until I work out a proper race/rally setup later. Tyres. I am running Yoko A052 in 235/45/18 all round, because that was what I could get in approximately the right height on wheels I had in the shed (Rays/Nismo 18x8 off the old Leaf actually!). As track tyres they are pretty poor; I note GTSBoy recently posted a porker comparo video including them where they were about the same as AD09.....that is nothing like a top line track tyre. I'll start getting that sorted but realistically I should get proper sized wheels first (likely 9.5 +38 front and 11 +55 at the rear, so a custom order, and I can't rotate them like the R32), then work out what the best tyre option is. BTW on that, Targa Tas had gone to road tyres instead of semi slicks now so that is a whole other world of choices to sort. Diff. This is the other thing that urgently needs to be addressed. It left massive 1s out of the fish hook all day, even when I was trying not too (you can also hear it reving on the video, and see the RPM rising too fast compared to speed in the data). It has an open diff that Infiniti optimistically called a B-LSD for "Brake Limited Slip Diff". It does good straight line standing start 11s but it is woeful on the track. Nismo seem to make a 2 way for it.
×
×
  • Create New...