Jump to content
SAU Community

Sau Vic Show And Shine Oct 21St 2012!


Recommended Posts

that thing was a machine lol.

I used to randomly see it do a quick lap on south gipsland highway every now and then, and then go into hiding for a little while..

lol no rego.

  • Replies 119
  • Created
  • Last Reply

Top Posters In This Topic

Yep it was Bens old 3ltr, not the custom 2.9 that was built later on

The shell went to Steve (another Vic member, who purchased Leewahs old car). Arrows going everywhere :D

Another shot of Jason-san's bay before the car was stripped.

Pity it never saw the purpose it was built for :(

6311678771_2112356712_b.jpg

ha ha na my cars different to jasons still 26 built in the mist of building a 27, mines got more aero than his! i do drive down south gippsland hwy a bit to goto work!

check out more on my fb page facebook/rpowermotorsports.

If anyone needs a Detail on Saturday or before just shoot me a message at the moment I still have some free spots.

Matt

Me Mav!!!!

Call me tomz!

can i pay my renewal on the day?

I'll be doing the same, so i'll get there a bit earlier.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Ahhh, I need the whole head unit. I definitely needed to roll back through and review your setup, ha ha! Neat setup they have going on. I just need a full double din head unit. But I want good and responsive. I might have to review what the likes of pioneer have out these days.
    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
×
×
  • Create New...