Jump to content
SAU Community

Recommended Posts

Is there a backlog for the approvals in "Projects, Overhauls and Build-ups" section?

Maybe the mod for the section is on a break?

I put up a new project over a week ago and hasn't popped up yet and the most recent approved project I can find was from about a fortnight ago.

Or did my thread mearly get turfed? :wacko:

Cheers

Joel had the same issue recently, it took some time to get approved but it went through and was worth the wait!.... I assume with the mods working hard on the Nationals etc there is just a lot to do :)

Look forward to your build thread :yes:

yep - mods are extemely busy at the moment due to nationals was the answer i got.

Be pateint or pm a supermod if you see one online - Ash was nice enough to approve mine (thanks again ash :-)

Edited by wedge_r34gtr

OK, significant backlog cleared, let me know if some have been missed.

Also, the best way to chase up an unapproved thread is to contact the section moderators first: N1GTR, Col-GTSX. Or another way is the "report this post" link which also goes to the section moderators....best way to spread the workload across the volunteer mods

  • 5 months later...

No, the problem is there is no thread started by you in either the build or motorsport build section. Not sure what happened but there is nothing there to approve. If you are concerned about the post just do a short intro in the first post and then once approved you can add more info.

Mate, I'm stuffed if I know what is happening....but there is no queued thread by you in motorsport builds from the last 2 days.

Can you start the topic somewhere else and send me a link, I will move it over to Builds

umm yep, you can't edit a post more than a couple of minutes after when you post it; we had to introduce that a few years ago to deal with dodgy trading.

I've removed that first line now too.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • New or used transmission? Alignment will be the same with engine running or not. If new, i'm presuming it's a clutch release bearing size issue. If used, are you certain it's a CD009/A and not an older CD008 or less? They had known synchro issues. In my opinion, these transmissions should always be purchased new, they're dirt cheap and you avoid dealing with old revisions. 
    • I like your thinking! Looking forward to see how it turns out.
    • You've got yourself a good old game of have fun. That shit is annoying as hell to remove. Thankfully for you, yours is on metal, most of the stuff I take it off is plastic, so typically hear guns are out. I normally end up continually dragging my thumb with pressure over it to get it to peel up. Eucalyptus oil then works well for getting residue and last remnants off.   Edit: plastic scraper might be worth while too. One that'll dig into the foam tape, but not scratch the paint.
    • So I ride and race motorcycles for fun and have always used a van to transport my track weapons. Figured towing a racebike with a skyline would be different and if done right could - "look fully sik" or quite cool for us grown ups lol. Pic of yours truly on two wheels I also have a trailer already kitted out to transport my bikes ...and I have a spare set of rims that match the car that I was going to rebarrel to get deeper dish at some stage but they have just been gathering dust. Sooooooo it is only logical.... Stay tuned !!    
    • If by "flap disc" you meant "chocolate wheel".... then they are OK for getting off stubborn remnants. But not for stuff with bulk depth. If by "flap disc" you meant "abrasive paint f**ker"....
×
×
  • Create New...