Jump to content
SAU Community

Recommended Posts

Thought I would post up my thoughts from my last track day on Wednesday @ the QR sprints

Previously every track day I have been to in my V35 I have always left the car in D mode with the PWR button pressed as the triptronic mode was far too laggy to be of any use

I recently had the transgo shift kit installed and was interested to see what sort of a difference it would make

I found that there were some pros and cons when it comes to trying to get your quickest time with the shift kit fitted compared to stock

The kit was good in the fact that I could drive the car like a manual in triprtonic mode and actually benefit from some sort of engine braking + the shifts happened for the most part in triptronic mode when I wanted them to unlike how the auto box behaves when its stock

I also managed to shave .16 off my best lap time however the improvement is somewhat on the small side that it could be attributed to a number of factors other than the shift kit

The negative, although I considered it more fun than negative was that the harder/faster shifts turned the car into a powerslide machine if I wasn't careful or more so if I wanted it to when shifting from 2nd to 3rd. This was with 245 Toyo R888 semi slicks on the back :woot: not so good for lap times however

I'm half keen to take the car to a Friday night drift session with some stocko 17's on the back given how easy it was to slide with the semi slicks on

Don't forget I am running an LSD unlike 99.999% of the other auto V35s out there

Link to comment
https://www.sau.com.au/forums/topic/413332-transgo-and-the-track/
Share on other sites

Luckily I had AWD, it loved the track, for about 2 laps before the trans went into overheating limp mode.

I don't think I would take a stock valve bodied car to the track though, the clutches would slip badly imo, causing more heat. Do you have a large trans cooler?

Have never been in limp mode cars been to 9 or so track days with around 20+ laps a day

Do run a trans cooler, dont think you would call it big but you can see the size in the pic + I run the best bang for buck cooling mod by removing the grill at the track so the car gets max airflow even tho it causes more drag

Also note that my tranny is going to be dealing with a lot less power than yours given you make double the power I do!!!

post-9102-0-07887700-1352383286_thumb.jpg

Edited by 180 wanabe

Don't forget I am running an LSD unlike 99.999% of the other auto V35s out there

Hey you keep saying this.......but every coupe that I have done a Transgo kit with in Sydney has had an LSD. Infact I am pretty sure it is standard equipment on manual or auto. The only difference being that the manual runs a 3.538 diff ratio and the auto runs a 3.327(or something).

Who said that the auto's don't come with LSD?

With the RE5 the line pressure is variable, meaning at light throttle is shifts silky smooth but when you plant it the shifts are firm. Definitely great for daily duties but it needs to be installed as per instructions, something professional transmission repairers seem to have a problem with.

The trans can be a little clunky compared to normal, not all the time just the occasional harder shift at light throttle or sometimes when dropping it back a gear. Nothing to worry about though. The clutches will last much longer without the drawn out slop into gear the factory valve body has.

Which suburb are you in Norby?

id be interested to know what the transgo is like for daily suties? I.e ido a lot of stop start driving, does it thunk between 1st and 2nd with little throttle?

mine isnt transgo brand (its custom made), and it does hit second quite hard regardless of throttle position. but this is in a 4 speed...

Custom made means it has some locally wound springs shoved in the place of the stock ones. This does not = shift kit. Yes it bumps up the line pressure but... Transgo have obviously spent a lot of research dollars sorting these kits out, replacing various pistons, adding valves and upgrading springs, all of which gives it the perfect crisp shift imo. I'm certainly glad my transmission specialist didn't cheap out and manufacture his own parts.

id be interested to know what the transgo is like for daily suties? I.e ido a lot of stop start driving, does it thunk between 1st and 2nd with little throttle?

im in Croydon North, im actually considering doing this mod. Just realised today the paint on my bonnet has been repainted and is all now peeling... if it isnt one thing its another with this f***ing car... i still love it though

Custom made means it has some locally wound springs shoved in the place of the stock ones. This does not = shift kit. Yes it bumps up the line pressure but... Transgo have obviously spent a lot of research dollars sorting these kits out, replacing various pistons, adding valves and upgrading springs, all of which gives it the perfect crisp shift imo. I'm certainly glad my transmission specialist didn't cheap out and manufacture his own parts.

Pretty sure MV Automatics are a bit more detailed than that

Hey you keep saying this.......but every coupe that I have done a Transgo kit with in Sydney has had an LSD. Infact I am pretty sure it is standard equipment on manual or auto. The only difference being that the manual runs a 3.538 diff ratio and the auto runs a 3.327(or something).

Who said that the auto's don't come with LSD?

I was sure I had found something about the diff specs of different V35 cars a couple years back. I know that the old diff in my car was crap and constantly peg legged at the drags/lit up the inside wheel when going around a corner at the track

If you can find an auto v35 that can throw down 2 black lines at the same time with the stock diff ill take my hat off to it who knows maybe a factory option, either way viscous sucks balls

copy pasted this from another forum:

2003 sedans didn't have an option for VLSD

2004-2006 sedans had a sport package option which came with VLSD

2007 sport sedans have VLSD, base & journey have ABLS

2003-2004 coupes had VSLD if it was a Performance Wheel and Tire package option, which meant 18" wheels auto or manual.

2005-2007 coupes only those with the Sport Suspension Package had VSLD

*The 18" wheel option for 05/06 is only that, wheels and tires

VLSD became part of the Sport Tuned Suspension package for 05/06*

Pretty sure MV Automatics are a bit more detailed than that

You hope.

I can guarantee they haven't put the same amount of R+D into their valve body upgrades that Transgo have. All I can go by is the local 'specialist' that makes his own springs, they aren't anywhere near as refined and simply bumping the line pressure gives clunky changes. If you are happy thats great but the RE5 is a completely different gearbox...

either way viscous sucks balls

And a two way doesn't? Give me a new tight oem Viscous lsd any day over a clunky mechanical. (for street)

There is no adjustment as far as I know, they will probably need to take the shims out from behind the line pressure spring in the valve body.

Perhaps a slightly thicker transmission fluid may help slow the clutch actuation down?

The diff option list above is for USDM

Best I can do.

Unless you've got a manual or an auto with 'sport package' then only way you'll know is by jacking it up and throwing it in nuetral.

Open diff's can twin up in a straight line though - my R31 had an open diff, and from a standstill it would light up both - have videos from the drags to show it.

Corners were a different matter though.......single peggers all the way!

And a two way doesn't? Give me a new tight oem Viscous lsd any day over a clunky mechanical. (for street)

I've had cars with open, viscous, 2 way and helical lsds and I'd say the best all rounder is the helical

Nothing puts hairs on your chest like going around a large roundabout in the wet with a nice tight 2 way :P

I owned a celica twin cam powered KE30 rolla with a migged diff for a few years, you get over it pretty quick, especially in winter. My favorite diff in the wet is the single spinner, no chance of stepping out with spider gears front and rear. AWD FTW. :)

Best I can do.

Unless you've got a manual or an auto with 'sport package' then only way you'll know is by jacking it up and throwing it in nuetral.

Open diff's can twin up in a straight line though - my R31 had an open diff, and from a standstill it would light up both - have videos from the drags to show it.

Corners were a different matter though.......single peggers all the way!

hey mate just a quick noob question,

when I jacked my car up on a hoist, and in N, the rear right wheel spins by itself, if I put my hand to it and hold it still, the rear left wheel starts spinning,

what sort of diff do I have?

cheers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I have been being VERY quiet about what you're alluding to, as it is something that ticks me off... The number of cars from factory that run coil overs is HUGE! Most of them these days do... The other part that annoys me, is people saying "Well all the incabin adjustable suspension is illegal by blah blah blah"... If that's the case, then why can I buy a car brand new that can do it if, FULL STOP in cabin adjustable suspension is illegal...   Also, I could just chuck some aftermarket shocks in my car, throw the stock springs on, after my blue slip, dump my super low springs back in. Same shock and spring style setup... Hell, they could also be the same colour springs etc.     I'm voting, BlueSlipper didn't want to touch the above car for some reason. Whether it be some sort of bias against the car, the owner, them maybe having previously done dodgy shit and now they're being super careful in case they get slapped in the face by the Gumbyment again... Find a new blueslip place.   And can confirm as you had said, yes there are holy bibles of vehicle heights, and all sorts of other suspension stuff. Heck your run of the mill mechanic, and tyre shop has access to all of that stuff. It's how they do wheel alignments...
    • Funny story Heading to Sydney this morning on the HWY there was some slow traffic, so I gave it the beans and midway through my overtaking "power run" I lost all power It seems that I missed a hose clamp,  and the MAF and filter went WiFi To make this more problematic, the little tool kit that lives in the boot, is sitting in the sun room at Goulburn......LOL Luckily for me I found a bit of steel on the side of the road that could be used like a rusty and bent flat head screw driver to tighten it up enough that it got me into Sydney, it is now all tight like a tiger with the aid of a 8mm socket Note to self: Use my brain and double check stuff, and always keep that little tool kit in the car for when I have a brain fart
    • Oh, and as for everyone with their fuel economy changes, I switch between E10 and 98 in the company car. Even do when I had personal cars that could run on E10. You know what changed my fuel economy in any noticeable way? How I drove, and where I drove. Otherwise, say on full tanks of just back and forth from work only (So same trips, same sort of traffic), couldn't notice a difference that I can correlate to the type of fuel in use. In the current vehicle, that's over 42L of USABLE fuel. While 98 is all "more energy dense", it also has higher knock resistance as it takes more energy to get it to ignite too. The longer hydrocarbons, typically more tightly bound. So running the same ignition map, can also produce less power, if there isn't enough time to get it all burnt through properly, as yep, the flame propagation speed is different from lower octane fuel to higher (Higher has a lower flame propagation, due to the more tightly bound and harder to self ignite funs. This is also typically where, a vehicle that is designed purely to run on 91 (Whether it be E10 or normal 91) usually sees absolutely no real world difference in fuel economy for the normal man, woman, or dog.
    • We've got some servos around me that have 91 with E10, 91 (no E10), 95, and 98. At those stations the change from 91 E10 to 91, is typically around 8c/L.   But lets not get started on the price of fuel in Oz. It's ridiculous. All the service stations around me, bar one, the price of fuel has been over the $2 mark per litre for the cheapest, 98 being around $2.45. That one service station is a CostCo, fuel from it comes from the same refineries, and makes no pitstops, it runs great, including the 98. In fact, I've had no issues on CostCo fuel, but plenty of issues at other stations!. The CostCo fuel, was $1.65 roughly this week for 94 with E10. $1.88 for 98. Servos directly across from it, $2.10 for 91 E10, and $2.48 for 98. The part I had to laugh at? If I drive multiple HOURS away from Brisbane, say out near Nanango, or Kingaroy, or even out to Goondiwindi, the price of their fuel, is the same as what it is at the CostCo... Oh, and that BP servo at Goondiwindi is HUGE and goes through epic turnover of fuel, so it's not sitting there for weeks going to shit. And what blows me away, my mate is one of the people who drives the Fuel Tanker all around QLD, delivering to all those places. At the same company his previous role was doing the "local haul" deliveries... Same truck, same driver, same pickup point it all comes from. So you tell me, how the hell it is 60c/L CHEAPER for fuel, when nearly all else is equal, except they require a B-Double to drive half a day out of Brisbane, and half a day back, every second day, compared to the delivery that can be under 30 minutes drive from the fuel pickup point... Not to mention, go five blocks down the road, and Ampol to Ampol will vary 30c/L... And I've had this conversation with my mate... The way it's priced, is just typical, pure and utter rubbish... He also does runs from Brisbane, to all over QLD, down to Newcastle, Sydney, Nowra, Melbourne, Geelong, and even out to parts of the NT depending on the companies needs. His main stuff is all the longer distance away from home for a few days at a time, then when he's back, he loves to just pickup extra shifts wherever he can in whichever truck, hence all the weird different places.   Oh, as for getting E10 into all the fuels in Australia... It was very quickly highlighted, that we don't have enough biomass available to use to make E10 sustainably like they require, and it would dramatically cut into our, and the worlds food chain supply...   I vote we all just start running on liquid methane gas... Plenty of that just getting tapped off at tips from underground decay... (Note, this is pure just stupid commenting. I could very easily highlight the reasons its not a good idea especially on scale...)
    • Am I correct in assuming that the R35's are getting the classic skyline haircut off the odometer?  Quick search on carsales, there are 33 08 and 09 GTR's for sale, only 2 of them have more then 100,000km's on them (116,075 and 110,000 respectively).  And somehow there are about 25 for sale with around 60,000kms? Looks like the classic skyline haircut to me =/
×
×
  • Create New...