Jump to content
SAU Community

R33 Stock Bov Flutter Sound - Whaddaya Reckon Of This?


Recommended Posts

Techinically its not legal as its making noise.... You will soon get over it as it will get old quickly!

This will not get the bishes moist!

  • Like 1

To your dignity.... yes....

There are SO many topics on SAU about BOV's and not running them, blanking them etc............

My understanding is that you could bend your turbo blades. By Blocking off the BOV the built up pressure that normally gets released to atmosphere or recirculated, has nowhere to go but back though your turbo and as such temporarily stalls the compressor, which can bend or brake the blades, and the stalling of the compressor is what gives the flutter sound.

  • 3 weeks later...
  • 1 month later...

Lawl! These threads always deliver!

But the whole flutter thing will soon be annoying for a daily drive!

AND you can get EPA's based on it anyway as its still creating a sound!!

In other words, DONT DO IT!

You f*#@Kin idiots..... The 'flutter' sound is called compressor surge. it is NO GOOD for your compressor blades, it slows down your turbo from spooling in between gears and in worst cases, f*#ks up your compressor blades.

Sometimes when people get too ambitious with sizing their aftermarket turbo and get the housing sizes wrong, or over fueling at idle because they didn't reconfigure their fuel map properly after they fit a bigger turbo, compressor surge OR 'flutter' is the result.

The whole purpose of having a BOV is to release the excess boost so it doesnt slow down your turbo in between gears.....its for response.....WTF would you sacrifice response for a sound ?????? fu*kin idiots

Man, I really wish these kids learn about the fundamentals of engine mechanics before they make a total dick of themselves or worse, totally ruin their cars.

Edited by NATAS

You f*#@Kin idiots..... The 'flutter' sound is called compressor surge. it is NO GOOD for your compressor blades, it slows down your turbo from spooling in between gears and in worst cases, f*#ks up your compressor blades.

The whole purpose of having a BOV is to release the excess boost so it doesnt slow down your turbo in between gears.....its for response.....WTF would you sacrifice response for a sound ?????? fu*kin idiot.

You sir are a f**kwit

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...