Jump to content
SAU Community

  

55 members have voted

You do not have permission to vote in this poll, or see the poll results. Please sign in or register to vote in this poll.

Recommended Posts

As all young guys who buy a skyline they try their chance in getting approved to drive their turbo skyline coupes for no other than hoon purposes, even if some may have LEGIT reasons they are mixed with the feelings of wanting to be behind a wheel of some power. I am no different.

I will be sending off my exemption form to VicRoads, as my circumstances (this is actually legit, believe it or not lol) are that I have MAJOR educational travelling issues.

I live in Meadow Heights, next to Broadmeadows, im sure most people from Victoria know. I go to La Trobe University Bundoora. Thus if I go by car It takes me about 40 minutes to drive there with little to none traffic, also depending on my route. Driving through barry road then Sydney road then freeway then plenty road then my University. Point is its fregging long and by transport, its much, much worse. pretty much impossible by public transport.

need to take bus at Broadmeadows then go all the way down then walk take a tram then walk to my uni, this takes about 1.5 hours of my time. that's 3 hours a day and I go 5 times a week about 3 hours a day so for 3 hours a day im going to be losing another 3 hours of my life.

mind you this is all legit, and so is the want to drive this turbo'd car, not going to lie.

fact is I have no other car to drive with. and NO SHIT I could've bought another car but believe it or not I got this pretty dam cheap and runs smooth, so hell why not take a shot.

Anyway told you the scenario. What are my chances, put a poll up.

Link to comment
https://www.sau.com.au/forums/topic/423438-will-i-get-my-exemption-approved/
Share on other sites

As all young guys who buy a skyline they try their chance in getting approved to drive their turbo skyline coupes for no other than hoon purposes

Wrong. I didn't, because I knew the rules and accepted them. I didn't have the arrogance to think I could loophole through the system. I'm usually a P-plate sympathiser, but you didn't start this post on a good note.

You're probably not going to get an exemption since you knowingly bought a car that you full well knew you are prohibited to drive, and you had equal opportunity to buy a car that's p plate legal. They're not going to accept "oh it was a good buy, so i bought it, now i've already got it..."

Edited by alex182

It may have been cheap but the running costs (fuel) is going to end up costing you much more than if you'd bought a cheap 4 cylinder. You have to run it on premium and your economy will be poor compared to a natro 4 cylinder. I hope you thought about all this, and the day to day practicalities if owning a turbo car when you are a uni student (who generally don't have much money).

And as Alex said, there are plenty of people who respect the law and don't act like a spoilt brat (not a dig at you personally, but all platers who buy a turbo car then try for an exemption).

No, you will get declined. I myself have a high powered vehicle exemption. But it is for work purposes, not just because i want to drive a turbo on my P's. I originally got knocked back on the application because i didn't provide enough information, a quick re-submit and a phone call to the lady that actually reveiws the applications and i was all set. I can drive whatever the hell i want between 6:30am and 6pm :)

But i still need to use P plates, which is annoying because i'm always in and out of different cars but i can live with it.

Sell the skyline and buy a cheap Fiesta or something until you can legally drive it.. i'm telling you now, you won't get approved.

1 As all young guys who buy a skyline they try their chance in getting approved to drive their turbo skyline coupes for no other than hoon purposes, even if some may have LEGIT reasons they are mixed with the feelings of wanting to be behind a wheel of some power. I am no different.

I will be sending off my exemption form to VicRoads, as my circumstances (this is actually legit, believe it or not lol) are that I have 2 MAJOR educational travelling issues.

I live in Meadow Heights, next to Broadmeadows, im sure most people from Victoria know. I go to La Trobe University Bundoora. Thus if I go by car It takes me about 3 40 minutes to drive there with little to none traffic, also depending on my route. Driving through barry road then Sydney road then freeway then plenty road then my University. Point is its fregging long and by transport, its much, much worse. pretty much impossible by public transport.

need to take bus at Broadmeadows then go all the way down then walk take a tram then walk to my uni, this takes about 1.5 hours of my time. that's 3 hours a day and I go 5 times a week about 3 hours a day so for 3 hours a day im going to be losing another 3 hours of my life.

4 mind you this is all legit, and so is the want to drive this turbo'd car, not going to lie.

fact is I have no other car to drive with. and 5 NO SHIT I could've bought another car but believe it or not I got this pretty dam cheap and runs smooth, so hell why not take a shot.

Anyway told you the scenario. What are my chances, put a poll up.

1 - No, not all young guys will, but people who wants to write off their car within 12 hours and selling it to me to wreck, will try (this has happened). I bought my NA R34 and it runs fine and I'm happy with it as a daily (very awesome daily as a matter of fact).

2 - No form of transport requires a turbo. Exemptions are granted if your vehicle is a turbo DIESEL or it is a utility vehicle such as a ute or other heavy workhorses, thus you would need to demonstrate or prove that it is necessary for the course of your employment.

3 - 40 minutes or not, does not require you to drive a turbo vehicle. Using this as an excuse will only let them think that you'd be speeding with your turbo car and hence get declined.

4 - Not really legitimate reasons for exemption.

5 - Then you should have bought another car.

There are two words that come into mind in this thread, they are "want" and "need". You basically NEED a metal box with 4 wheels that can take you from A-B. You WANT a turbocharged fast metal box with 4 wheels, to take you from A-B.

However this is coming from Nanny NSW. Might be less tougher in VIC.

I personally think that your chances at getting an exemption is next to 000.0001%. Though if you do get approved then I'll personally fly down there and buy you a beer :cheers:

I'm due to apply for one over the coming months, though I have a legitimate reason as I now work in the automotive industry.

What type of car is it? I just got mine for a r33 gtt. I dyno'd and weighed it and got approved no worries.

Not to sure on Vic rules but if your car is 125 at the wheels or less than it is at the legal max at the fly. If it is look into it and apply

On another note. They are REALLY!!! REALLYYYY thirsty.

I can see your reason but I agree with the 4 cly n/a thing, I'm considering going back to my ford focus and driving the skyline on weekend so I can wait till I get a pay Rise to pay for fuel.

Edited by cowdy

When I was attending Uni it took me 2 hours by public transport there and back. That's 4 hours a day, 5 days a week. Did this for about 1 and a half years.

I did not ask for an exemption. Instead I worked hard, saved my money and bought a P-Plate legal car.

No offence but I do think you went about this the wrong way but either way good luck to ya!

When I was attending Uni it took me 2 hours by public transport there and back. That's 4 hours a day, 5 days a week. Did this for about 1 and a half years.

I did not ask for an exemption. Instead I worked hard, saved my money and bought a P-Plate legal car.

No offence but I do think you went about this the wrong way but either way good luck to ya!

exactly. i did that through uni (for 3 years mind you) AND now working at the same uni, it is my daily commute (insert face palm). suck it up OP...

If it takes 40 mins by car from Broady to Bundoora then you are doing it wrong.

The point remains - you didn't need to purchase a illegal car, so why should you be exempt? If I was the person responsible for reviewing your app, you'd be denied

  • Like 1
  • 10 months later...

Sorry to bring up an old thread but I just got done last night by highway patrol driving my stagea do I'm going to try for an exemption again. Is there any way to get a tuning shop to do a low power dyno run so the car still comes up under powered? I have a fmic, 3" turbo back, hypergear op6 highflow and 255lph walbro pump. Do they inspect the car for mods or can you just hand them a dyno sheet and the results from weighing the car?

I doubt you'll get one, and there are plenty of wagons you could've bought that are not on the banned list; so I doubt that will fly as a reason.

They will have a listing with the factory power for the engine, and will use that rather than a deflated dyno figure you are clearly using to try & get around the rule; everyone know's you're going to bump the power straight back up anyway; right?

Sometimes it's better to wait until you don't have to break the law, and drive the car you are allowed to drive.

Why do P platers insist on buying cars they cannot legally drive? I dun get it.... Go out and buy a VL like 90% of them, do some skids. When you can legally drive a real car buy it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Who did you have do the installation? I actually know someone who is VERY familiar with the AVS gear. The main point of contact though would be your installer.   Where are you based in NZ?
    • Look, realistically, those are some fairly chunky connectors and wires so it is a reasonably fair bet that that loom was involved in the redirection of the fuel pump and/or ECU/ignition power for the immobiliser. It's also fair to be that the new immobiliser is essentially the same thing as the old one, and so it probably needs the same stuff done to make it do what it has to do. Given that you are talking about a car that no-one else here is familiar with (I mean your exact car) and an alarm that I've never heard of before and so probably not many others are familiar with, and that some wire monkey has been messing with it out of our sight, it seems reasonable that the wire monkey should be fixing this.
    • Wheel alignment immediately. Not "when I get around to it". And further to what Duncan said - you cannot just put camber arms on and shorten them. You will introduce bump steer far in excess of what the car had with stock arms. You need adjustable tension arms and they need to be shortened also. The simplest approach is to shorten them the same % as the stock ones. This will not be correct or optimal, but it will be better than any other guess. The correct way to set the lengths of both arms is to use a properly built/set up bump steer gauge and trial and error the adjustments until you hit the camber you need and want and have minimum bump steer in the range of motion that the wheel is expected to travel. And what Duncan said about toe is also very true. And you cannot change the camber arm without also affecting toe. So when you have adjustable arms on the back of a Skyline, the car either needs to go to a talented wheel aligner (not your local tyre shop dropout), or you need to be able to do this stuff yourself at home. Guess which approach I have taken? I have built my own gear for camber, toe and bump steer measurement and I do all this on the flattest bit of concrete I have, with some shims under the tyres on one side to level the car.
    • Thought I would get some advice from others on this situation.    Relevant info: R33 GTS25t Link G4x ECU Walbro 255LPH w/ OEM FP Relay (No relay mod) Scenario: I accidentally messed up my old AVS S5 (rev.1) at the start of the year and the cars been immobilised. Also the siren BBU has completely failed; so I decided to upgrade it.  I got a newer AVS S5 (rev.2?) installed on Friday. The guy removed the old one and its immobilisers. Tried to start it; the car cranks but doesnt start.  The new one was installed and all the alarm functions seem to be working as they should; still wouldn't start Went to bed; got up on Friday morning and decided to have a look into the no start problem. Found the car completely dead.  Charged the battery; plugged it back in and found the brake lights were stuck on.  Unplugging the brake pedal switch the lights turn off. Plug it back in and theyre stuck on again. I tested the switch (continuity test and resistance); all looks good (0-1kohm).  On talking to AVS; found its because of the rubber stopper on the brake pedal; sure enough the middle of it is missing so have ordered a new one. One of those wear items; which was confusing what was going on However when I try unplugging the STOP Light fuses (under the dash and under the hood) the brake light still stays on. Should those fuses not cut the brake light circuit?  I then checked the ECU; FP Speed Error.  Testing the pump again; I can hear the relay clicking every time I switch it to ON. I unplugged the pump and put the multimeter across the plug. No continuity; im seeing 0.6V (ECU signal?) and when it switches the relay I think its like 20mA or 200mA). Not seeing 12.4V / 7-9A. As far as I know; the Fuel Pump was wired through one of the immobiliser relays on the old alarm.  He pulled some thick gauged harness out with the old alarm wiring; which looks to me like it was to bridge connections into the immobilisers? Before it got immobilised it was running just fine.  Im at a loss to why the FP is getting no voltage; I thought maybe the FP was faulty (even though I havent even done 50km on the new pump) but no voltage at the harness plug.  Questions: Could it be he didnt reconnect the fuel pump when testing it after the old alarm removal (before installing the new alarm)?  Is this a case of bridging to the brake lights instead of the fuel pump circuit? It's a bit beyond me as I dont do a lot with electrical; so have tried my best to diagnose what I think seems to make sense.  Seeking advice if theres for sure an issue with the alarm install to get him back here; or if I do infact, need an auto electrician to diagnose it. 
    • Then, shorten them by 1cm, drop the car back down and have a visual look (or even better, use a spirit level across the wheel to see if you have less camber than before. You still want something like 1.5 for road use. Alternatively, if you have adjustable rear ride height (I assume you do if you have extreme camber wear), raise the suspension back to standard height until you can get it all aligned properly. Finally, keep in mind that wear on the inside of the tyre can be for incorrect toe, not just camber
×
×
  • Create New...