Jump to content
SAU Community

Recommended Posts

My understanding was always that the knees come in when you're approaching your weight limit. You might have to do some assistance exercises or maybe some band work to help you at the problem point.

When do your knees start turning in? Coming up or going down?

I'm not savvy enough on squat mechanics to suggest which muscle you want to target, Rev would have a better idea, but I'm thinking anterior adductor (inner thigh) and ITB (outer quad) stability could be a problem?

I've used brackets just in case my terminology is wrong :)

Yeah it started doing it at 50kg last night which isn't that heavy for me, but yeah the 60kg was bad it was making my whole body lean to the left as I was coming up.

My knee is fine going down, it's as I come back up that it bends in and it's only the right knee, so therefore it's my left leg predominantly the adductor that is weak?

I was wondering if just doing leg extension, leg curls and lunges on the left leg would help at all

Left leg/glute is weaker than the right; right knee is coming in to save the day and you're shifting the weight over the right leg when the weight gets too heavy for the left to push it's share.

It's a mobility issue that needs to be trained out of the CNS, not unlike a dominant arm during bench press but more exacerbated. Your adductors aren't weak, you just don't know how to use them (or moreso, not use them) to keep the right leg from coming in to save the day when "shit hits the fan" and the left leg/glute can't drive anymore.

Interesting. Stuff, I'd say the right is compensating for the left.

EDIT: Birds just posted the same thing.

Anyway, you can do single leg work to bring the left up to par.

I had to do that back in the day of trying to get bench weight up. Trained left side to stop right compensating.

That or stick to a weight both legs can comfortably drive with and slowly increase weight until they are synchronized.

If used to do it on 40kg but now that she has surpassed that (making left leg stronger), it doesn't. It wasn't doing it on 50 recently but I'd say muscle tiredness is likely responsible for this particular incident.

01/05/14

Deadlift

60kg x 10

80kg x 5

100kg x 1

110kg x 1

80kg x 10

80kg x 10

Bench Press

20kg x 10

30kg x 5

40kg x 3

47.5kg x 1

40kg x 7

Bicep Curl

10kg x 10

15kg x 10

20kg x 5

20kg x 5

20kg x 3

Push-ups

20

Ab work

05/05/14

Squat

20kg x 10

40kg x 10

50kg x 5

60kg x 1

62.5kg x 1

50kg x 10

40kg x 10

40kg x 10

Pause Squat

40kg x 5

Lat Pulldown

30kg x 10

40kg x 10

45kg x 10

50kg x 10

55kg x 7

60kg x 3

65kg x 1

Seated Row (cable)

30kg x 10

35kg x 10

40kg x 10

45kg x 5

50kg x 4

55kg x 2

Captains Chair

40

30

30

09/05/14

Deadlift

60kg x 10

80kg x 5

100kg x 1

112.5kg x 1

90kg x 5

80kg x 10

80kg x 10

Bench Press

20kg x 10

30kg x 5

40kg x 3

50kg x 0

45kg x 2

40kg x 8

Bicep Curl

10kg x 10

15kg x 10

20kg x 5

20kg x 4

20kg x 4

Decline Ab Crunch with 5kg plate

10

10

10

Hanging Leg Raises

10

10

10

Pull-ups

2

12/05/14

Squat

20kg x 10

40kg x 10

50kg x 5

60kg x 0

60kg x 1

65kg x 1

50kg x 10

50kg x 5

Lat Pulldown

30kg x 10

40kg x 10

45kg x 10

50kg x 10

55kg x 7

60kg x 3

65kg x 1

Seated Row (cable)

30kg x 10

35kg x 10

40kg x 10

45kg x 5

Ab work

You women are all the same lol

Couldn't just say thanks, had to play it down.

Just accept the damn compliment :D

I did 25 reps of squat with a massive 25kgs on the weight belt last night and my back did not explode, awww yeah.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...