Jump to content
SAU Community

Recommended Posts

This happened.

v80jdv.jpg

v4vyw4.jpg

4q3myo.jpg

Panasports 18 x 10.5 +22

Tomei Expreme Ti catback.

Hunting for some Mines front pipes now to finish off the sound.

Bad news is pushing small amount of coolant from head, so heads coming off to do gasket and studs. Will fab up some hard pipes for the cooler hoses and a catch can set up so that everything is ready to push the turbos.

Will retune for 25psi or so and see how we go

  • Like 7
  • 1 month later...

Quick update,

Had engine out and installed:

Hks head gasket

Arp studs

Head check and clean etc

Custom battery and catch can

Black -10 lines and fittings.

Drain from can to sump

Restrictors in head and block

Baffling in the cam covers.

All oiling side is taken care of now so hopefully don't have to worry about it.

Goes in for power run in morning to double check everything and may turn up wick couple psi will play it by ear.

Will also anodize the catch can black for stealth at some point.

Once again beautiful work from Josh and the lads, wonce its black will look almost factory.

6qzf2x.jpg

5ehbh0.jpg

  • Like 5

White was the only colour I was looking for too and got very lucky with timing. Second choice would be wine red which most people hate haha.

Experienced one negative of new can, dropped the coolant overflow lid down the side and took ages to get out.

  • 1 month later...

Those wheels look hot!!!!

Do you have an updated photo of your front lip?

Thanks :), yeah quick garage 2dtvcsm.jpg

Wheels look awesome, what exhaust are you running and does it have a silencer in the rear muffler ?

Tomei expreme cat back and blitz front pipes which will soon swap for equal length.

It does have a silencer can slip in but haven't used it.

Wheels suit so much!

Only thing is keeping them polished is a pain may have to seal them. Edited by Ambi3nce
  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...