Jump to content
SAU Community

Recommended Posts

As delusional as Maldanado this bloke.

http://www.planetf1.com/driver/18227/9487921/JEV-I-showed-my-potential

Scrappiest of races with penalities, running off the road left right and centre...yet is claiming it as his arrival drive. Where did he qualify again? :) Hack. Off you go to Nissan LMP1 program and leave Romain to fly the F1 flag

obvious troll is obvious

I'm just going to leave this here:

Last 2 races:

Singapore

12 13 Pastor Maldonado Lotus-Renault 60 +66.9 secs 18

13 8 Romain Grosjean Lotus-Renault 60 +68.0 secs 16

Italy

14 13 Pastor Maldonado Lotus-Renault 52 +1 Lap 16

15 99 Adrian Sutil Sauber-Ferrari 52 +1 Lap 14

16 8 Romain Grosjean Lotus-Renault 52 +1 Lap 17

what's that saying? "you're only as good as your last race", or in this case two lol

Edited by hrd-hr30

hmmm,

a "foreign substance" contaminated the electronic circuits in his steering column...

then a later tweet says

the contaminant was a substance used in normal pre-event servicing of the component.

dodgy. If it was a nomal substance used in normal servicing, why would you call it a foreign substance/contaminant? Funny how this normal substance used in normal pre-event servicing only found it's way into the electronics immediately as the cars rolled out for the race, not at the start of the event.

f**k it, i had to listen to years of Webber conspiracy theorists! :P

hmmm,

then a later tweet says

dodgy. If it was a nomal substance used in normal servicing, why would you call it a foreign substance/contaminant? Funny how this normal substance used in normal pre-event servicing only found it's way into the electronics immediately as the cars rolled out for the race, not at the start of the event.

f**k it, i had to listen to years of Webber conspiracy theorists! :P

What substance would you use to "service" a wiring loom that would potentially contaminate the electronics that the loom plugs in to?

Think hair gel is a more believable explanation.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
×
×
  • Create New...