Jump to content
SAU Community

Recommended Posts

There is the potential it will destroy your engine too.

Why not just buy a Hypergear? Cheap, high quality thrust/bearings, properly balanced, with local warranty. I try and back the Aussie made products if I can... No way I would want to push an Egay gt35 to 150,000 revs. ;)

Ive seen the vid of a t70 the compressor wheel was no bigger than a t04 just with a big ass housing on it. Its what its labled as anyway so no doubt its a mix match or smaller than a genuine garrett. Getting it balanced and good seals put in if it blows it blows

why would you buy a dim sim special turbo, re balance it and re seal it, etc.. it will end up costing as much as a proper turbo to begin with.. if you're really keen on ling long special turbos at least go with a Kando peking duck special.

And will do ben lol I had no issues with the ebay 38mm gate I used on my v8

A wastegate is something i consider you might get away with, as per your experience. Not worth the risk in my opinion if it sticks shut.

Also, it doesn't spin at 100,000 rpm. ;)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I’m here solo don’t have any hands to help so haven’t hit it with a timing light 
    • When you crank your car, and hit it with a timing light, can you see a steady crank timing?
    • Oh, forgot to add, A few months ago I was getting mixture codes and the car was using crap loads of fuel. You could smell the unburned fuel in the exhaust, it was crazy strong. Economy was over 17.5 l/100 and usually around 19. I smoked the engine and found a leaky CCV hose which I replaced and then I replaced my two pre cat O2 sensors, I also replaced the MAF. This fixed my mixture codes and improved my exonomy but I'm still 14 - 15 l/100 when pottering about town so something is still amiss. Throttle response is much better and it has more pep but I'd like to know why it's still so thirsty (and I'm hoping that whatever it is gives me a bit more poke).    
    • Car is on factory injectors/z32 maf/ q45 throttle body/ z32 ecu with nistune 
    • Hello all, currently finishing up a rb25 swap into my s14. Having issues with starting, car has spark (confirmed by pulling a plug and watching it spark), has fuel(confirmed by checking pulse/voltage at injectors all spark plugs are soaked in fuel). Car cranks over and pops into the exhaust with a heavy fuel smell but no attempt to start or run, I have torn the timing cover off and triple confirmed timing, turned the CAS in multiple spots both directions, attempted to start with coolant temp and maf unplugged, checked my fuel lines and made sure they weren’t backwards, checked voltage at cas/injectors/coilpacks, made sure all the grounds in the harness are connected and added a few grounding straps (1 from chassis to block, 1 from chassis to head, and 1 from chassis to igniter chip) I am getting stumped here. As a last ditch effort I made a full grounding harness tonight that’s going to run from the battery and add an extra ground from the battery onto the coil pack harness/igniter chip/ intake manifold/ Wiring specialties harness ground/ and alternator. I’m hoping maybe the grounding harness will fix it here but posting here to see if anyone has any other ideas on what else I can check. My fuel pressure is unknown right gauge will be here tomorrow.  IMG_3206.mov
×
×
  • Create New...