Jump to content
SAU Community

Recommended Posts

how goes the newly minted loinspawn? Getting much sleep?

My youngest came over to  dinner to display her first tattoo last night.

I actually quite liked it :P

Aaaand same as last holiday up north..... car breaks down near Carnarvon on the way home... thinking MAF or TPS. Idled 50km back to caravan park from gorges. Now to study up so I can test stuff in the morning. Nearest town 175km

12 hours ago, t_revz said:

Aaaand same as last holiday up north..... car breaks down near Carnarvon on the way home... thinking MAF or TPS. Idled 50km back to caravan park from gorges. Now to study up so I can test stuff in the morning. Nearest town 175km

Fark dude.

I know a pretty good auto sparky......

38 minutes ago, turboedsloth said:

I can not confirm nor deny that i have tested it

In the words of the great sage of our time, Kevin Bloody Wilson

"...if you say you don't, your a liar, and a fool if you say that you do...."

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

waaay sweeter than you expected, amiright?

  • Like 1

Happy Friday all!

My mechanic in Texas doesn't reply to my emails with "No worries" or "sounds good", oh no. He replies with "10 4" and it makes me smile every damn time.

  • Like 1
15 hours ago, t_revz said:

Aaaand same as last holiday up north..... car breaks down near Carnarvon on the way home... thinking MAF or TPS. Idled 50km back to caravan park from gorges. Now to study up so I can test stuff in the morning. Nearest town 175km

Ah fk.




  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...