Jump to content
SAU Community

Recommended Posts

  • 4 weeks later...
  • 1 month later...

What did you put in it Kat?

And does it go.....  clunk de clunk de clunk?  I hate that.

Mine is the V-spec and from what I can see it's a pain to put a 'normal' diff back in but looks like I have no choice with what I do with the car.

Is there an option other than to a 1.5 now? Is there a tru-track available anyone?

12 hours ago, DJBarnstar said:

Does the Nismo 1.5 go clunk de clunk de clunk?

I personally have not done my diffs to confirm or deny, though that is what i will be doing. 

@Piggaz Should be able to answer that for you if he is nice enough....

12 hours ago, DJBarnstar said:

Does the Nismo 1.5 go clunk de clunk de clunk?

The GT PRO is quite cranky with the Nismo oil it comes with. I switched to the OSG 80W-250 and it shuts it up by 85%. This was with solid alloy diff bushes but I've ditched them and put some Nismo rubber bushes in. Haven't driven the car yet but it should be a lot better again.

  • Like 2

I think you can get quafe for the rear as well. It also might be worth checking that the fluid is topped up for the rear diff. Right side of  the boot from memory.

Or you could sell it back to me.... :P

  • Like 1
On ‎15‎/‎11‎/‎2016 at 5:10 PM, DJBarnstar said:

Does the Nismo 1.5 go clunk de clunk de clunk?

 

On ‎16‎/‎11‎/‎2016 at 5:41 AM, Piggaz said:

The GT PRO is quite cranky with the Nismo oil it comes with. I switched to the OSG 80W-250 and it shuts it up by 85%. This was with solid alloy diff bushes but I've ditched them and put some Nismo rubber bushes in. Haven't driven the car yet but it should be a lot better again.

Like Piggas says.  Diff goes clunkety clunk even on the lowest setting.  Change the oil and it becomes liveable.

  • Like 2
  • 4 weeks later...
1 hour ago, DJBarnstar said:

Should I try and swap the current Nismo end caps with someone for stock GT-R ones?

 

I'm leaning that way.

 

What do you think?

20161216_200529.jpg

20161216_200547.jpg

I have a brand new set in packaging if you wish to swap. A bit of money your way too.

And thanks for the lead Anfanee. 

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I’m not sure what happened I told them about sonic tunes free OTS tune and the next the I know .. I was booted..   To funny 
    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
×
×
  • Create New...