Jump to content
SAU Community

Recommended Posts

From my own perception, the Bose system does indeed sound better than the Clarion system. That said, though reasonably better than my BA wagon's crap, I consider both versions to be shite anyway.

However, as I outlined in my write up on upgrading one's sound system in a V36, for the sake of making the installation an easier process, it is better to get a vehicle with the Bose system so that you can minimise rewiring in the vehicle if you decide to run split component speakers front and rear, unless you aim to push huge amounts of power, that is.

The Bose head unit is actually worse than the Clarion if you put an aftermarket amp into the car. The amount of crap it outputs is amazing. White noise galore. Had to install a processor to get rid of all the crap

What kind of processor? Neither system is terribly clean but by design, the Bose should be cleaner as it feeds the OEM amp in the boot with a balanced line level signal. With a good DSP, it should be able to take advantage of that balanced feed and therefore significantly reduce any analogue issues. If you tried to just feed those line level signals straight into an aftermarket amp without any balanced to unbalanced matching transformers at least, if not a well-designed DSP, then I'm not surprised you got the noise.

Anyway, for my ears, all car audio systems ideally need some kind of DSP. Just a couple of tone and bass controls doesn't cut the mustard. Not all speakers are created equal, nor are amps, nor are the sources. Only when you have that detailed level of control will you squeeze the most out of it all and probably end up running it cleaner which means less abuse of your speakers.

Mine has a very slight DC offset, which gives a little white noise as a consequence. I could design a line driver which would process the DC offset out of the speaker leads but it's only noticeable at low volumes and I barely run mine below moderate.

i have had cars with both and bose is much cleaner at higher volume levels, its much clearer overall and better bass too. i would recommend wait for a Bose model to come up if u can, 

  • Like 1

We basically tried taking signals anywhere from the head unit to the factory amp in hopes to be able to get a decent signal. There wasn't much luck with powering a good set of speakers and subs. So we had to use aftermarket amps. In which we were met with pretty bad crappy signals. So now I have a bit ten installed. Boss head unit has own eq added onto the signal. Any signal you take coming from the head unit will already have the crappy eq added onto it. The DPS strips the signal down and gives the amp a clean signal to play with.

I'm not a big fan of how Bose has implemented the system and the speakers are pretty meh IMO. If you're gonna pay extra $$ for the Bose system, it may be cheaper or more worthwhile just getting the non Bose and put in aftermarket amps, speakers and subs.

i have had cars with both and bose is much cleaner at higher volume levels, its much clearer overall and better bass too. i would recommend wait for a Bose model to come up if u can, 


Yeah Bose is cleaner n clearer due to the "better" amp and speakers over the non Bose.
16 hours ago, AsM said:

i have had cars with both and bose is much cleaner at higher volume levels, its much clearer overall and better bass too. i would recommend wait for a Bose model to come up if u can, 

Same

15 hours ago, colin.ssc said:

We basically tried taking signals anywhere from the head unit to the factory amp in hopes to be able to get a decent signal. There wasn't much luck with powering a good set of speakers and subs. So we had to use aftermarket amps. In which we were met with pretty bad crappy signals. So now I have a bit ten installed. Boss head unit has own eq added onto the signal. Any signal you take coming from the head unit will already have the crappy eq added onto it. The DPS strips the signal down and gives the amp a clean signal to play with.

Here's the thing though. You're feeding a balanced audio signal into an amp which likely only took unbalanced audio and at probably vastly different impedances too. If not properly matched, you will get the hiss/white noise you referred to. That has nothing to do with how Bose manipulate the audio through their built-in DSP. Sometimes you can get away with grounding the cold phase of a balanced signal directly but sometimes, if the impedance is way off, you need to use transformers (baluns) or active matching, which is what you've essentially achieved by using the Audison Bit.One, as I believe that also supports balanced and unbalanced inputs.

But then the EQ'ing and delays that they introduce to suit their speakers, I agree, you then need to use your own DSP to counteract all that so that you can flavour it to the aftermarket speakers you've decided on, as they'll have different characteristics. The Audison Bit.One is a pretty good unit, so you definitely did well there but that's the nature of adapting things that weren't necessarily made to be adapted.

Again, in my opinion, to do the sound right, all audio systems (home, professional and mobile) require DSPs to squeeze out the most performance out of your rig. I can't imagine not using a DSP in any scenario, personally.

  • 2 years later...

Hi, I had the bose set up in mine and it was shit!  Out of all the mods I've done ripping the factory bose HU/sat nav, amp and all speakers out and replacing with aftermarket was the best mod!

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...