Jump to content
SAU Community

Recommended Posts

Hi all,

 

I'm making around 250rwkw in my r33 gtst with a hypergear op6 highflow.

 

My exhaust of right (3 inch system) now is a bellmouth dump pipe, to venom 100cell cat, then straight to a jasma cannon. However the jasma cannon reduces to around 2.5 inch.

 

This setup is fairly loud but not too bad when cruising and light throttle.

 

I want to replace the cannon with a piece of 4 inch straight pipe. Mainly because i want to remove the 2.5 inch restriction, i like the look and i can do it fairly cheap. I don't want the exhaust to be insanely loud or drone heaps. A little louder than now is ok.

 

If i install a hot dog resonator after the cat, will this be enough to reduce noise a bit and keep drone down? Or will i have to install a different type of muffler?

 

 

Link to comment
https://www.sau.com.au/forums/topic/469953-exhaust-system-help/
Share on other sites

'zactly.  There is a logical limit to how big a muffler under the floor can be.  You obviously need 3" in and out, and it is quite likely that you will need it to be centre-centre because it will be going in in place of a piece of straight pipe.  So your typical oval mid muffle will only be so tall and so-so wide.  Your main degree of freedom is the length, and there will only be so much freedom there.  Get the longest one in the catalogue.

I just checked my exhaust and the way its the piping goes doesnt allow space for a mid muffler.

I also drove the car with a straight pipe (was doing hicas delete so had to drop rear exhaust) just to see how loud it was. Needless to say its unbearingly loud, i got about 20 angry looks even though i drove around at low rpms.

Can anyone recommend me a rear muffler ( preferably dual tip ) that flows well but is quiet?

5 minutes ago, vxsr33 said:

I just checked my exhaust and the way its the piping goes doesnt allow space for a mid muffler.

I also drove the car with a straight pipe (was doing hicas delete so had to drop rear exhaust) just to see how loud it was. Needless to say its unbearingly loud, i got about 20 angry looks even though i drove around at low rpms.

Can anyone recommend me a rear muffler ( preferably dual tip ) that flows well but is quiet?

http://www.smb.net.au/ovalmufflers.htm

They will do a twin tip if you ask

I added a photo of a single tip, 4 inch offset in, centre out for reference. Can be made I any length you want. 

IMG_2027.JPG

  • Like 1
Or leave it as is. At 250KW you are not going to gain a lot from going to 3in. Save up til you can afford a good muffler.

The main reason i want to change is the drop to 2.5 inch really bugs me and I'm over the look of the cannon.

Not expecting any noticeable performance increase.
  • 2 weeks later...
  • 1 month later...

And the pipework looks 3 inch while the his exhaust is 3.5 if I'm right?

 

Was looking at this before but had another idea, joining the end of the chamber the end where it's capped to the actual exhaust (without actually drilling through. Just not sure if it'll still be effective that's all)

 

Saves the hassle of having to find a way to mount the chamber

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...