Jump to content
SAU Community

Recommended Posts

R32 GTR Shuts off driving

I'm having an issue with my '89 R32 GTR. Twice now it has shut off completely while driving and after about 25 or 30 minutes it will finally start up again. This has happened after taking a hard pull and then coasting with the clutch pushed in. After pushing in the clutch the rpms blip a thousand or so and then go down to normal and then a mile or so down the road the car just shuts off. I can continually try to start the car and it will try to turn over but won't start until about 25 or 30 minutes later it will just start up. After it happens the car drives normal and reaches full boost and full power no problem. It was about a week or so between the 2 issues. Originally I thought it was an issue with the alternator which was found to be bad, so that was replaced with an upgraded Nissan Quest unit. Even with the boost turned all the way down on the ebc, it will fluctuate between 19psi and about 21psi. Is that normal to not have a dead on reading all the time? It was at 20.8 psi when it shut off the last time.

It is frustrating because I was doing hard pulls earlier and had no issues. I had done hard pulls in the week or so between the 2 instances and didn't have a problem. If anyone have any suggestions I'd appreciate it.

Car has:

HKS GTIII SS turbos

Tomei Expreme Outlet Pipe

HKS Front Pipe

R33 Catalytic Converter

HKS Silent Hi-Power Exhaust

Apexi Power Intake Kit

Nismo Fuel Pump with rewire

Injector Dynamics 725cc Injectors

R34 Coilpacks and conversion on Wiring Specialties harness to remove Ignition Module

Link ECU using built in map sensor with mafs disabled, o2 sensor removed and tuned for wideband

HKS Vcam

HKS 264 Exhaust Camshaft

Greddy Profec B EBC

 

Link to comment
https://www.sau.com.au/forums/topic/472057-r32-gtr-shuts-off-driving/
Share on other sites

Awesome thanks. I will try and test the CAS.

Any suggestions on the boost issue? Is it possible the turbos are flowing too well with less restrictions in the exhaust, causing an increase in the boost? The shop I have work on it say that it's dead on 19 psi on the dyno and that it isn't a boost leak but on the street it goes over 19 psi.

I had an AEM boost solenoid being controlled by the link but with the boost issues it was hitting boost cut and I thought it was easier to be able to make adjustments on my own with the profec instead of a laptop with software I didn't understand. As soon as the boost issues are resolved I plan on going back to the link controlling the boost though. Also I wasn't sure if the link was originally having issues controlling the Vcam and the boost at the same time with it spooling so quickly.

Thank you for the graph. That looks pretty smooth on your boost. I think I have gotten my boost issue figured out. The first shop I had work on it forgot to remove the brass pill from the line so now that it's gone it only fluctuates between 1.21 bar and 1.32 bar. Now just waiting to see if the cas issue is fixed.

  • 3 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sorry to hear your HFM BM57 was faulty,  did you contact HFM I would hope they would be at least grateful for the information if there was some sort of manufacturing fault, you would hope they would be sympathetic even if your item was 2 years old if it had never been fitted. May I ask where it leaked from ?
    • Cats are called Bella, and Donna...  Like that poisonous plant And I remember your 2 monsters, I remember making a little bit of wee when you let them out... LOL I have already installed cat doors into the laundry where their kitty litter is, and the sun room, apart from the cat doors there's not going to be any permanent mounted stuff on the interior walls (interior doors are cheap and easy to replace) I will get a outdoor cat cage thingie once I finish the landscaping out back... https://catnip.com.au/ The only off limit areas are the main bedroom and the gym room....but, currently the cats are curled up in bed, in the main bedroom with the Mrs.....LOL, the off limits for the kittens to the main bedroom lasted about 5 minutes with Jackie I currently only have 1 free standing huge cat tree multiple level scratching post thingie in the lounge room, but, I will be getting another one soon now that I'm happy with the furniture layout in the back room and have a perfect spot for it  
    • All of this is making it seem clear that running the Coppermix twin was definitely the way to go, especially in hindsight with how insane tariffs have gotten and the strength of the USD vs yen at the time.
    • That sounds like no chance of even importing one for road registering then Now I see why Duncan wants to check LHD rules for Targa...   I wonder how "bolt in" the AWD would be if you got one imported from the US and swapped it to an AUD one
    • Not to mention they drive like a bucket of bolts! yuck!
×
×
  • Create New...