Jump to content
SAU Community

Recommended Posts

Hi all,

recently I changed my spark plugs. Went from heat range 6 to 7 as the previous ones were white (running too hot). Not sure why though, because the engine is stock. 

A days of driving later I noticed a bad smell coming from outside when the window is opened. Only while I drive over 60kmh. If the window is closed there is no smell at all, also not from the A/C. So my guess is that it's either because of the ignition or spark plugs.. or the catalyst. Or maybe both? From what I know is that defect spark plugs can damage the cat. On the other hand the car is running fine, no misfire, etc. Only that bad smell. 

Anyone had this before? Could it also be something else? 

Thanks!

Check nothing came unpluged or disconected when the plugs were done.
It doesnt take much.
A vacum leak, a disconected sensor or plug.

Doughtful but If the old plugs were shagged the long term trims may be out badly. If its a stock ecu do a hard wire reset to see if it helps.

Thanks, I'm gonna have a look that everything is connected.
Could it also be caused by a boost leak? The turbo makes a high pitched sound when boosted but I'm not sure wether it's the old ceramic turbo or a leak. Also on my list of things to check. 

How about the fuel pump?

Arhg! I hope the turbine wheel isnt scraping the housing inlet. Turbo rebuild time if so and i wouldnt drive it like that..
Check if the turbine can pull back to the entry and see if its hitting.
A boost leak usualy causes richer than normal but still possible to throw shit out of wack.

Then that's the first thing I'm gonna do. Just to be sure. The boost noise is there since I bought the car a year ago. So I believe it's just the bearings or a leak. If hitting, then it would be long dead I guess. First time turbo removal for me, that's gonna be fun. 

After that: Check all connections, other leaks, sensor, catalyst, change fuel filter and maybe fuel pump.

You dont need to remove the turbo. Just the intake pipe to it. So you can see the turbine propeller. If the shaft moves to far toward the inlet where the pipe came off it can scrape.
You been on stock boost so it may last a year.

Turbo seems fine. No scraping, shaft play minimal up and down, not horziontal. In and out a very very little. Feels like 0.5 mm. But again, I can't make it scrap by hand. My guess is that the whining  noise is coming from the bearing or some boost leak. 

That bolt loose shouldnt cause a boost leak. Maybe a zorst leak.... wich may cause the fuel ratios to be read wrong by the 02 sensor and changing the part throttle fuel trims.

 

On the bright side the turbine prop looks ok. Is that a bit of grease on the fins?

 

Bit of rubber hose is easy to replace dont stress. It may have been perished anyway.

 

Hmmmmm tighten up the bolt and see if it helps.

 

If that turbo is highflowed and on low boost it may be a bit loud from the waste gate working harder to keep boost down.

 

I have never heard of spark plug temps causing such an issue with smell. The way you described it. Could it be wiring? Just maybe load for the plugs is making things hot~???

 

Maybe someone will chime in soon that has had a similar issue

 

 

  • Like 1

Sorry to be a sad sack but.

If a car is pinging badly on boost the noise can be high pitch (not a whistle but similar) and it will eat itself from the inside. If the plugs are white that means lean...lean on boost means pinging due to less timming , heat and pressure is needed to ignite and will have increased temps leading to detonation from heat induced pre ignition.

Id be checking the fuel filter , fuel pressure , flow and regulator.

Were any old plugs different color to the others?

There is so many things that can cause a lean condition and so many driving occasions that things can occur at.
Research a lot.
Asking doesnt always help.
If your mech or tech happy you should be fine to figure this out. Otherwise take it where it can be tested and diagnosed.

From... un metered air - undelivered fuel- incorrect timming.

Un metered air-
breathing post maf pre turbo, unpluged , dirty or dead maf.

Undelivered fuel-
pump (bad flow/dead), ecu(control/tune), injectors(dirty/loose conection/dead) , filter (blocked) ,sender (can cause bad flow not switching 9v idle-12v throttle), maf(dirty/dead/unpluged) ,fuel regulator(should rise 1-1 with boost),
O2 sensor(part throttle and boost transition lean condition)

Timing out-
Tune, incorrect maf/tps/cas sensor readings to ecu.

Ok thats all that i can think of right now that is a possibilty. Im sure theres more.

Goodluck.

  • Thanks 1

Thank you for your help, really appreciate it. Now I know better where to look for. 

I tighten it up, clean the maf and see if that already fixed the problem. I read that an exhaust leak also could leak to bad smell and bad performance. 

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • It is a kunfine Android screen . Does anyone know the wirering diagram of the fuga ??
    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
×
×
  • Create New...