Jump to content
SAU Community

Recommended Posts

Hi all,

recently I changed my spark plugs. Went from heat range 6 to 7 as the previous ones were white (running too hot). Not sure why though, because the engine is stock. 

A days of driving later I noticed a bad smell coming from outside when the window is opened. Only while I drive over 60kmh. If the window is closed there is no smell at all, also not from the A/C. So my guess is that it's either because of the ignition or spark plugs.. or the catalyst. Or maybe both? From what I know is that defect spark plugs can damage the cat. On the other hand the car is running fine, no misfire, etc. Only that bad smell. 

Anyone had this before? Could it also be something else? 

Thanks!

Check nothing came unpluged or disconected when the plugs were done.
It doesnt take much.
A vacum leak, a disconected sensor or plug.

Doughtful but If the old plugs were shagged the long term trims may be out badly. If its a stock ecu do a hard wire reset to see if it helps.

Thanks, I'm gonna have a look that everything is connected.
Could it also be caused by a boost leak? The turbo makes a high pitched sound when boosted but I'm not sure wether it's the old ceramic turbo or a leak. Also on my list of things to check. 

How about the fuel pump?

Arhg! I hope the turbine wheel isnt scraping the housing inlet. Turbo rebuild time if so and i wouldnt drive it like that..
Check if the turbine can pull back to the entry and see if its hitting.
A boost leak usualy causes richer than normal but still possible to throw shit out of wack.

Then that's the first thing I'm gonna do. Just to be sure. The boost noise is there since I bought the car a year ago. So I believe it's just the bearings or a leak. If hitting, then it would be long dead I guess. First time turbo removal for me, that's gonna be fun. 

After that: Check all connections, other leaks, sensor, catalyst, change fuel filter and maybe fuel pump.

You dont need to remove the turbo. Just the intake pipe to it. So you can see the turbine propeller. If the shaft moves to far toward the inlet where the pipe came off it can scrape.
You been on stock boost so it may last a year.

Turbo seems fine. No scraping, shaft play minimal up and down, not horziontal. In and out a very very little. Feels like 0.5 mm. But again, I can't make it scrap by hand. My guess is that the whining  noise is coming from the bearing or some boost leak. 

That bolt loose shouldnt cause a boost leak. Maybe a zorst leak.... wich may cause the fuel ratios to be read wrong by the 02 sensor and changing the part throttle fuel trims.

 

On the bright side the turbine prop looks ok. Is that a bit of grease on the fins?

 

Bit of rubber hose is easy to replace dont stress. It may have been perished anyway.

 

Hmmmmm tighten up the bolt and see if it helps.

 

If that turbo is highflowed and on low boost it may be a bit loud from the waste gate working harder to keep boost down.

 

I have never heard of spark plug temps causing such an issue with smell. The way you described it. Could it be wiring? Just maybe load for the plugs is making things hot~???

 

Maybe someone will chime in soon that has had a similar issue

 

 

  • Like 1

Sorry to be a sad sack but.

If a car is pinging badly on boost the noise can be high pitch (not a whistle but similar) and it will eat itself from the inside. If the plugs are white that means lean...lean on boost means pinging due to less timming , heat and pressure is needed to ignite and will have increased temps leading to detonation from heat induced pre ignition.

Id be checking the fuel filter , fuel pressure , flow and regulator.

Were any old plugs different color to the others?

There is so many things that can cause a lean condition and so many driving occasions that things can occur at.
Research a lot.
Asking doesnt always help.
If your mech or tech happy you should be fine to figure this out. Otherwise take it where it can be tested and diagnosed.

From... un metered air - undelivered fuel- incorrect timming.

Un metered air-
breathing post maf pre turbo, unpluged , dirty or dead maf.

Undelivered fuel-
pump (bad flow/dead), ecu(control/tune), injectors(dirty/loose conection/dead) , filter (blocked) ,sender (can cause bad flow not switching 9v idle-12v throttle), maf(dirty/dead/unpluged) ,fuel regulator(should rise 1-1 with boost),
O2 sensor(part throttle and boost transition lean condition)

Timing out-
Tune, incorrect maf/tps/cas sensor readings to ecu.

Ok thats all that i can think of right now that is a possibilty. Im sure theres more.

Goodluck.

  • Thanks 1

Thank you for your help, really appreciate it. Now I know better where to look for. 

I tighten it up, clean the maf and see if that already fixed the problem. I read that an exhaust leak also could leak to bad smell and bad performance. 

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
    • Nice car! I’m glad folks in the US have gotten past the FnF and are buying real cool cars like the 260RS I was with a bunch of mates in Portland about a year ago and spotted a green Stagea (just a regular 2.5T AWD) parked about 2 blocks away and they were like “a what?” So I made a bet with them for a round of beers and said “ok one of you run down there and tell me if the steering wheel is on the correct side” 5 mins later the American comes trudging back up the hill and goes “he’s right guys. Ok what beer do you want?”
    • Should replace OR drop the tank, give it's good clean. Might be worth replacing that entire fuel level/pump/cradle thing with this: https://frenchysperformancegarage.com/products/fpg-s13-180sx-r32gtst-single-pump-hanger-kit-billet-hat-6-v3-fpg-089?gQT=2  
    • Thank you so much for the help
×
×
  • Create New...