Jump to content
SAU Community

Recommended Posts

Hey Guys,

I'm buying a 89 240SX with RB20DET swap for my little brother.

He currently is having problems with the rev limit.

The motor won't rev past 5500RPM.

He has installed three different RB20 ECU's. After about 15 minutes after each ECU swap he's done, the computer trips and wont let the car go past 5500RPM. But, it will rev fully for about 15 minutes after he swaps them.

I have been ragging my mind trying to think of what could be causing it.

I have had this problem on cars with bad boost sensors, where they are overboosting, and the ECU puts a clamp on RPM.

But, the guy I am buying the car from is saying the RB20DET doesn't have a boost sensor.

I have never swapped one and don't have any experience with that motor.

List of things checked/replaced:

ECU (3 different ones)

NEW ECT

air control valve

aac valve

MAF (3 Different ones)

CAS (2 different ones)

Compression tested (145-160 psi across the board)

scoped bottom end (no damage)

igniter chip (2 different ones)

tested all coil packs

Any ideas?

Chris

Heres when he started having problems:

"When I took it to emissions, it was sitting there about 15 minutes, when the water started boiling in the recovery bottle. I turned off the car and let it cool down.

Driving it home, the intercooler hose, hose between pipe and hot side of intercooler, blew apart."

He had somebody tow him home. He had it parked for 3 weeks. Installed the Hybrid FMIC and has had problems ever since.

He mentioned that when in neutral he can rev all the way to redline. It's only when he's underload, driving, that he has this problem.

I just can't figure out why its not sending a code to the ECU. It doesn't make any sense.

I'm wondering if it might have something to do with the wiring on sensors on the transmission.

He mentioned that when in neutral he can rev all the way to redline. It's only when he's underload, driving, that he has this problem.  

That doesn't mean much - I once had a truly blocked fuel filter that would allow the engine to free-rev till the cows come home, yet it was virtually impossible to get the car to move from stationary.

Check the available fuel pressure when the problem is happening.

What happens when it gets to 5500? Does it bounce hard off a limiter, does it gradually get slower as it approaches 5500, then just not go any harder? Can it go past 5500 using part throttle or going down a hill? All of these will help to narrow down where the problem lies.

I doubt the transmission or the wiring to/from it is the problem. Basically if you're getting a speed reading, your reverse lights work, and (if it's auto) the idle compensation works when you click it in/out of gear, then it's all working fine.

I think I know the prob.

Are you trying auto or manual ecu's?because someone I know had the same prob with his manual RB20det with a auto ecu,we put my manual one in and she rev'ed to redline. :)

  • 9 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Was there ever a model of the Stagea m35 that didnt have a badge on the grill? I thought I saw that somewhere, some aero edition or something? I cant find it again? davemoto
    • Its a 2002 vr-x four VQ25DET, silver. Coil overs, lowered, polished alloys and sport exhaust. Bit of a project, was sitting in a shed for a while but runs and drives great.
    • I wasn’t able to replicate the sound anymore. It was a one time sound so maybe it was just coincidence but it was like small pebbles being dropped in a coke can.   should I try cleaning the MAF? It could be it’s functioning but dirty? I don’t know.
    • Update 4: Hi all. The car drives again! Haven't driven for long, only to store it in the garage again, but the test drive was successful. The coolant and oil leaks seem to be fixed for now. Temps on the engine were also very good, while moving I never even saw 80C water during the approx. 30 minute drive. Ate up all the coolant in the reservoir though so will have to fill that even more when I go to the car next time. One thing that pisses me off is that the RPM gauge is still f**ked, I even resoldered the board twice and used copper paste on the silly screws that are used as connections. Next time I take it out I'll take apart the board and fit new components, I'll see if I can get a replacement IC for it.  I have an appointment set for 22nd of September for the engine tune to 370hp. Alignment also still needs to be done. My hope is that I can get all the legal stuff over with by the end of this season. Anyone of you have advice regarding intercoolers? Currently there is an APEXI core fitted, one of those weird hybrid ones, 600x270x76. I don't think it's bad but it's not new and now I still have the chance to change it now to legally include it in the paperwork. Only issue is that the only options that would arrive in time are a HKS Type R intercooler or generic Ebay spec intercoolers comparable to a JustJap one. Ideally I'd order a Plazmaman but it takes over a month to receive which would mean making the car legal has to wait until next season. Would love to hear some input on this. Same story for my injectors, the previous owner was a nunce and put ID 1050x on the engine. They work but are obviously not ideal at "normal" power levels. But I don't see a reason to change them unless the tuner says it's necessary. I read online before buying a different exhaust that the top secret style rear diffusers won't fit due to the size of the rear resonators. My buddy and I made it work by slightly "adjusting the shape" of the mounting bracket and making some spacers out of 3d print for the mounting bolts. Fits like a charm. Just putting this here in case someone has this problem. Even the hefty HKS Silent Hi Power rear can fits without hitting anything.
    • Well they got my money but they are not getting my gearbox ! 
×
×
  • Create New...