Jump to content
SAU Community

Recommended Posts

Spotted a white RS M35 on Wellington Rd, near Rowville yesterday... looked like Prince Skyline's car perhaps?

Flashed the highbeams and gave a wave as it came towards me (I was in the white Prado with trailer)

Spotted a white RS M35 on Wellington Rd, near Rowville yesterday... looked like Prince Skyline's car perhaps?

Flashed the highbeams and gave a wave as it came towards me (I was in the white Prado with trailer)

That would have been me if it was around 11:15/11:30 - On my way home from daughter's soccer in Narre Warren - always take Belgrave-Hallam Road then Wellington Road.

Didn't see you though - not that i would have blinked an eye. Often get flashed along Wellington Road for speed cameras...........

Spotted a blue NM35 series 1 around 5:30pm between Medlow Bath and Blackheath going east on the GWH. I thought I was looking in the mirror...same as mine. Didn't have my glasses on so only saw it as it was going past. Sorta waved but the 'A' pillar was in the way for the other party to see. So now I'm waving :action-smiley-069:

Black C34 at Tyres and More Prospect yesterday morning as I walked to work.

Black C34 (maybe the same one?) on South Road this morning.

Black C34 on south road may have been me, did you see the car from the front or the back?

Pale green S1 at Nerang.I Parked nose to nose. Talked to the owner who does not post much. Stag was Nina's who lived here on Tamborine. It went thru NizPro with a respray.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...