Jump to content
SAU Community

Recommended Posts

im getting my fc installed and tuned at chasers for 450 and for a retune of fcs the charge 132 for the first hour and 88 for every hour after that? does that seem ok i was going to get a service there but they want 750 for all this

Full service includes - timing belt/seals, engine oil (motul 4100), oil filter, gearbox oil, diff oil, fuel filter, spark plugs, coolant, fluid topup and general inspection. $750

cheers simon

also are chaser any good now they seem to do alot of motecs now not fc's

Edited by gt-t_r34
  • Replies 57
  • Created
  • Last Reply

Top Posters In This Topic

  • 2 years later...
  • 2 weeks later...

1. COST - $1000

2. Mods you have done - FMIC, Pod Filter, Apexi Turbo, Extractors, 3inch Full Exhaurst, Cams, PFC

3. Where u did it - Gentech, Canberra

4. How long it took - 2 Days, Full Tune from blank and cold start.

5. Comments - Very happy with the end result and the after service help.

It sounds a bit expensive then what every one else has said but they did tune the car all day as he was ringing me as he did it. so for all the time and the end result i think it was worth it.

Adam

  • 9 months later...
  • 3 weeks later...
  • 2 months later...
Cheap tunes arent always good tunes, my last tune cost me about $8k in a rebuild so-far

yea your rite, for an extra few hundred its worth goin sumwer wer they will do a decent job, atelast you will save yourself the $$$ thousands in the long run if it blows up

i pay 900 at racepace nd can say confidently its worth every dollar...

price: 900

mods: fully rebuilt rb26, cams, turbos, fmic, etc, etc...

Just got mine fitted and tuned at Autotech recently.

Paid around 700+ for the tuning alone (my first tune)

Very happy with the results but not perfect as somehow something is making the boost controller not holding boost.

Just got mine fitted and tuned at Autotech recently.

Paid around 700+ for the tuning alone (my first tune)

Very happy with the results but not perfect as somehow something is making the boost controller not holding boost.

mmm....I was just thinking the other day how you would have gone with Gavin....so they had it for 3 hours i'm guessing.

1. COST - $700 for full first time tune

2. Mods you have done - FMIC, Apexi Pod Filter, GT3071R, Exhaust, Profec B, Spitfire Coilpacks, 550cc Injectors, Walbro Pump, z32 AFM

3. Where u did it - Unigroup Engineering in Sydney

4. How long it took - Gave it in about 5 days ago to put the turbo, injectors, fuel pump, AFM and PFC. Should be done in 10 days total

5. Comments - I've heard good things about unigroup and the initial meeting went very well. They have kept me informed of the progress. Will update when I have the car back.

Edited by usmair

Yea 3+ hours on a 4wd dyno. Made 255awkw @ 1.1-1.15bar boost, 165awkw @ 0.6bar before. Not looking at the figures, the car shit loads faster and smoother. Complete joy to drive now comparing to before.

  • 1 month later...

thanx now i got a price to work with!!

Charged: $100

Mods: FMIC, 3" Turbo Back Exhaust, PFC, RB30DET.

Tuned By: Shaun @ Boostworx in Adelaide, SA

Time Taken: 1hr (I Hung Around)

Comments: Very happy, The 3ltr only 'just' ran on the stock RB20DET 2ltr PFC base map. Very good tune for bugger all bills.

The tune was 90% wot tuning with a few little light load adjustments.

It made 176rwkw with the stock RB20DET turbo running 9psi @ 4400rpm-4950rpm, power drops off rapidly after this rpm.

I've reached the limit of the stock rb20 turbo and injectors as they are hitting 100%.

I will be installing injectors and a larger turbo soon, I've been told the tune will cost $200-$300 as he will have to completely go over the light load map. This is what takes time, not the WOT.

1. COST - $300 for full tune

2. Mods you have done - FMIC, Apexi Pod Filter, HKS GT-RS, Exhaust, E-Boost Street, Spitfire Coilpacks, 550cc Injectors, GTR Pump, Z32 AFM, Tomie poncams, CP Pistons, Jun Style Front facing plenum with 80mm TB.

3. Where u did it - SouthCoast Rotary Performance (in Woollongong, NSW)

4. How long it took - About 4 hours

5. Comments - Excellent tune for the money, being a rotary tuner he knows how to set a good ignition map before taking the fuel out. Engine makes good power, with zero knock. Also spent some time on light load, to improve economy.

  • 3 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I have been being VERY quiet about what you're alluding to, as it is something that ticks me off... The number of cars from factory that run coil overs is HUGE! Most of them these days do... The other part that annoys me, is people saying "Well all the incabin adjustable suspension is illegal by blah blah blah"... If that's the case, then why can I buy a car brand new that can do it if, FULL STOP in cabin adjustable suspension is illegal...   Also, I could just chuck some aftermarket shocks in my car, throw the stock springs on, after my blue slip, dump my super low springs back in. Same shock and spring style setup... Hell, they could also be the same colour springs etc.     I'm voting, BlueSlipper didn't want to touch the above car for some reason. Whether it be some sort of bias against the car, the owner, them maybe having previously done dodgy shit and now they're being super careful in case they get slapped in the face by the Gumbyment again... Find a new blueslip place.   And can confirm as you had said, yes there are holy bibles of vehicle heights, and all sorts of other suspension stuff. Heck your run of the mill mechanic, and tyre shop has access to all of that stuff. It's how they do wheel alignments...
    • Funny story Heading to Sydney this morning on the HWY there was some slow traffic, so I gave it the beans and midway through my overtaking "power run" I lost all power It seems that I missed a hose clamp,  and the MAF and filter went WiFi To make this more problematic, the little tool kit that lives in the boot, is sitting in the sun room at Goulburn......LOL Luckily for me I found a bit of steel on the side of the road that could be used like a rusty and bent flat head screw driver to tighten it up enough that it got me into Sydney, it is now all tight like a tiger with the aid of a 8mm socket Note to self: Use my brain and double check stuff, and always keep that little tool kit in the car for when I have a brain fart
    • Oh, and as for everyone with their fuel economy changes, I switch between E10 and 98 in the company car. Even do when I had personal cars that could run on E10. You know what changed my fuel economy in any noticeable way? How I drove, and where I drove. Otherwise, say on full tanks of just back and forth from work only (So same trips, same sort of traffic), couldn't notice a difference that I can correlate to the type of fuel in use. In the current vehicle, that's over 42L of USABLE fuel. While 98 is all "more energy dense", it also has higher knock resistance as it takes more energy to get it to ignite too. The longer hydrocarbons, typically more tightly bound. So running the same ignition map, can also produce less power, if there isn't enough time to get it all burnt through properly, as yep, the flame propagation speed is different from lower octane fuel to higher (Higher has a lower flame propagation, due to the more tightly bound and harder to self ignite funs. This is also typically where, a vehicle that is designed purely to run on 91 (Whether it be E10 or normal 91) usually sees absolutely no real world difference in fuel economy for the normal man, woman, or dog.
    • We've got some servos around me that have 91 with E10, 91 (no E10), 95, and 98. At those stations the change from 91 E10 to 91, is typically around 8c/L.   But lets not get started on the price of fuel in Oz. It's ridiculous. All the service stations around me, bar one, the price of fuel has been over the $2 mark per litre for the cheapest, 98 being around $2.45. That one service station is a CostCo, fuel from it comes from the same refineries, and makes no pitstops, it runs great, including the 98. In fact, I've had no issues on CostCo fuel, but plenty of issues at other stations!. The CostCo fuel, was $1.65 roughly this week for 94 with E10. $1.88 for 98. Servos directly across from it, $2.10 for 91 E10, and $2.48 for 98. The part I had to laugh at? If I drive multiple HOURS away from Brisbane, say out near Nanango, or Kingaroy, or even out to Goondiwindi, the price of their fuel, is the same as what it is at the CostCo... Oh, and that BP servo at Goondiwindi is HUGE and goes through epic turnover of fuel, so it's not sitting there for weeks going to shit. And what blows me away, my mate is one of the people who drives the Fuel Tanker all around QLD, delivering to all those places. At the same company his previous role was doing the "local haul" deliveries... Same truck, same driver, same pickup point it all comes from. So you tell me, how the hell it is 60c/L CHEAPER for fuel, when nearly all else is equal, except they require a B-Double to drive half a day out of Brisbane, and half a day back, every second day, compared to the delivery that can be under 30 minutes drive from the fuel pickup point... Not to mention, go five blocks down the road, and Ampol to Ampol will vary 30c/L... And I've had this conversation with my mate... The way it's priced, is just typical, pure and utter rubbish... He also does runs from Brisbane, to all over QLD, down to Newcastle, Sydney, Nowra, Melbourne, Geelong, and even out to parts of the NT depending on the companies needs. His main stuff is all the longer distance away from home for a few days at a time, then when he's back, he loves to just pickup extra shifts wherever he can in whichever truck, hence all the weird different places.   Oh, as for getting E10 into all the fuels in Australia... It was very quickly highlighted, that we don't have enough biomass available to use to make E10 sustainably like they require, and it would dramatically cut into our, and the worlds food chain supply...   I vote we all just start running on liquid methane gas... Plenty of that just getting tapped off at tips from underground decay... (Note, this is pure just stupid commenting. I could very easily highlight the reasons its not a good idea especially on scale...)
    • Am I correct in assuming that the R35's are getting the classic skyline haircut off the odometer?  Quick search on carsales, there are 33 08 and 09 GTR's for sale, only 2 of them have more then 100,000km's on them (116,075 and 110,000 respectively).  And somehow there are about 25 for sale with around 60,000kms? Looks like the classic skyline haircut to me =/
×
×
  • Create New...