Jump to content
SAU Community

Recommended Posts

  • 4 weeks later...

Skyline model: R34 Gtt

Wheel diameter: 18"

Wheel width: 9" Front and back

Wheel offset: +22 Front and back

Tyre size: 235/40/18

Modifications to fit: Front guards are rolled, but not needed, no scrub at all, and no camber.

Perfect fitment for a gtt imo. So happy with them

post-129215-144927090009_thumb.jpg

post-129215-14492710949244_thumb.jpg

  • Like 2

Hey guys need some assistance...

Looking at running these on a 32 GTR Vspec in one of the below sizes.. Will I have any issues? Can run negative camber although not looking to roll guards..

19x9.5J 114.3 +50 / +30

19x10.5J 114.3 +25 / +15

advan_gt_2.jpg


Edited by GRKGTR

They will look aids in that size. Stick to 18's

9.5+30 will be sunken

10.5+25 is the best option there and will work but need a lip probably

But yeh... 18's

  • Like 1

They will look aids in that size. Stick to 18's

9.5+30 will be sunken

10.5+25 is the best option there and will work but need a lip probably

But yeh... 18's

They are also available as 10.5 +15 in 18s

Trying to achieve this look although with a bit more dish.. Reason I was looking at 19s is so I don't have to have the car at an illegal height to fill guards.

http://www.motormag.com.au/media/2699068/nismo-festival-4.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
×
×
  • Create New...