Jump to content
SAU Community

10/01/2003 Cruise pic post & chat thread


Recommended Posts

  • Replies 208
  • Created
  • Last Reply

Top Posters In This Topic

so buying a bloody tripod this month... pictures turn out shakey and shit without it... the only ones that turned out well that i posted in the other thread were cause i put the camera on my polish box and the posts there :D

was a good turn out... when we have the club up and running (reminds me to hurry up and get the DBs done)... we will organise some... will most likely be posted in a private members forum rather than slapped on public forums like MCCR and OCAU and the like to keep some of the "unwanteds" out and keep it SAU only.

we should have a computer meet or something so we can swap footage, etc. heh.. and the red ford au or xr? when we took that wrong turn... nice u-turn hehehe. you held it in a very jap-spec way :D also props to skyline33 and mznismo for the organising and such.

nah wasnt mine then.... mines stock apart from POD and Zorst and ECU and Adj. Shocks...

only time i generally go over the limit down centre dandy is at 1am on the way home where from that petrol station to half way down i normally hit over 200 if the rds empty.... even if i see one car i'll keep below the limit.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Good to hear. Hopefully you're happy enough not to notice when driving and just enjoy yourself.
    • I mean, most of us just love cars. Doesnt necessarily have to be a skyline.
    • Did you pick up a manual cluster to remove the position indicator?  (Pretty sure the 34 has the gear position in the cluster, but it's been a while)
    • Here is a recipe. Sonic blocks till you get one that has a good enough bore. Get a torque plate and block brace, use your choice of fasteners (arp ect) bolt the thing together empty, half fill it and let it cure. Release it when it has, go to a REPUTABLE RB Builder and get the thing line bored/honed and cylinder honed to size, then wash. Once its all clean and dandy, wash and blow it out again. Then again.  Assemble said engine to your desired clearances with oil control mods, gasket to suit desired CR/Squish ect. Attach your extended sump with proper trap door oil baffles and head drain plumbed to sump with a SUMP BREATHER SYSTEM. Build your front diff with a decent LSD, rebuild your transfer case with a few extra plates, more than likely replace your tailshaft centre bearing and tighten up the rear diff. Tune to minimise excessive midrange cylinder pressure (timing unless you like to split bores and rebuild engines) Enjoy your engine, but hate the fact you are now destroying engine mounts, gearboxes, gearbox mounts, diff output flanges and driveshafts, diff mounts, tailshafts and front CV's.   Disclaimer.... Ive never done any of the aforementioned stuff.......
    • 440s will support well over 400HP on petrol, which is a decent place to be for an RB20. 230+rwkW. Will be a safer bet for idle/low load. 550s would be nice for the extra headroom. I've made the same decision with mine (Neo25). 1000s are probably too big for the Nistuned ECU, so I have some smaller ones.
×
×
  • Create New...