Jump to content
SAU Community

Recommended Posts

Spotted my cars: silver manual (stock), and blue manual (Charge Speed car) still at compliance... Hopefully will be spotting them in my driveway by mid December, just in time for Xmas! :)

Spotted a h00n in blue V35 Coupe plate no WLB5** on Dynon Rd this afternoon going towards Footscray, cutting our daily car from the left lane to the right lane, narrowly missing our front left corner, then braking so hard and almost slammed to the back of the ute in front.

It's a bloody rush hour traffic jam, you stupid t00l, where do you think that kind of manouver will take you? You didn't get any faster as you still got stuck in Dynon traffic anyhow. Thank's for that a$$h0le, now I know who sow the seeds of 'bad image' for skyline drivers. You better not be on this forum as it's a disgrace.

Spotted very clean look one on Victoria road West ryde sydney today @ 7:50 AM. Silver with infiniti badge front , debadged rear. aftermarket exhaust, aftermarket fog light. smocked/tinted tail light. 19' dish wheel. plate "MD-xxx" Really sexy. I am the silver v35 with black NISMO LMGT wheel on your right.

Spotted very clean look one on Victoria road West ryde sydney today @ 7:50 AM. Silver with infiniti badge front , debadged rear. aftermarket exhaust, aftermarket fog light. smocked/tinted tail light. 19' dish wheel. plate "MD-xxx" Really sexy. I am the silver v35 with black NISMO LMGT wheel on your right.

I also spotted this V35 driving up balaclava rd. I was in a metallic blue v35.

That's funny, I was in a blue V35 driving on Balaclava Rd too... in Melbourne :P

Lucky we are not talking about King St, Queen St, George St, Elizabeth St. ETC, otherwise every one on form will pop up and say: Yeh, I was in that street that day. :):P

  • 1 month later...

someone should sticky this thread...

spotted R35 GTR 1 rego on logan road about 20 mins ago silver in colour.. the old fella said to me nice gtr you have its a rare colour i dont think he knew i had the baby version of it lol

Always see the red coupe in Carinbah, also one selver with exhaust in Wolli Creek( where i live), Silver one in Maroubra, Blue one in Coogee and a black one in Ryde. Iam in blue coupe with dark tint, and unbadged from today.=)

Spotted black V35 coupe at Gate 7 Eastern Creek yesterday after the drive night was washed out.

There were a few other nice rides there:

Lexus ISF

M6

RS4

Lambo Diablo VT (I think)

'vette C6

pity it got canned would've been nice to see these run.

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
    • Shimmed or shimless, still solid, no hydraulic pump up stuff.
    • They have said food will be limited. Mainly meat pies and sausage rolls from memory. But they have a coffee van!
×
×
  • Create New...