Jump to content
SAU Community

Recommended Posts

Cops seem to be out alot lately, I'm figuring its to do with the numbers game since it's almost June 30. They tend to try and catch up for the EOFY, up til about Sept, when they do as much work as possible, then go somewhere and die for a while.

Spotted quite a few cars all day today. Cops were also out in force. I've been seeing them roaming the roads a lot lately. Everytime I notice red and blue lights behind me I automatically think it's going to be me that they're chasing but every time it happens they always approach the rear of my car slowly and stay behing me for like a minute or so then speed off at like 150kp/h in the right lane again.

Red R34 GT-t along the Princes Fwy on the way to work in the morning whilst caught up in the traffic jam, then a white R32 GTS-t, Silver Evo 7 or 8 and another R34 this time in white all driving along Claredon Street throughout various times of the day. At the end of the day on Cooper Street, Epping I was driving alongside a white R33 GTS-t for a while before I turned off back on to the ring road (god, I miss having an RB), then caught glimpse of a black S15 ADM GT-Spec weaving through traffic along the Western Ring Road around the northern parts, also spotted a white FC RX7 sitting low with awesome looking stance (great fitment) and finally a red S15 Spec-R also along the Princes Fwy as I was approaching Geelong.

Hang on, one more... black R34 GT-t (I think) with ?chromies?! whilst I was turning right to head back home at the interection after I reached the end of the freeway, he was turning left into the small shopping centre complex.

Phew! Tomorrow, a new day of spotting begins again. :)

Edited by GT32

Also forgot to mention one more. Last one I promise!

I spotted GDZGTR again (actually driving this time, lol. normally I always see it sitting stationary) on the same street in Epping that my mrs lives on when I dropped her off tonight. If you're on here mate I was gonna give you a beep but had already gone too far. I was the white S15 btw. If I see you around again I'll give you a beep/wave :).

Edited by GT32

I only do them once a week now on weekends cos it's dark when I get home from work during the week :( I do miss doing them nearly daily

You would have seen me but I was driving my sisters excel turning into the middle hotel. My car is chilling at home till the defect is cleared. How often do you do the steps? I'm going to get back into it next week

Clean silver V35 350GT with white-on-black personalised plates drove past my car around midday today which was parked along Coventry Street, Sth Melb.

Had to park in the 45deg angled park all day for around $9 because for the life of me I can't seem to find decent (free) all day parking around that particular area. Yesterday I couldn't find a spot at all so I had to use the underground secure car park which cost me $25 for 4 hours! Cops were everywhere again all day today... It's just going to be a matter of time before I get pulled over again, I can already see it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Has equal chance of cleaning an AFM and f**king an AFM. I think you can work out what happened. When the Hitachi ECU sees the AFM die and goes into the associated limp mode, then it will start and run just fine, because it ignores the AFM and just runs on idle maps that will do what it needs to get it going. But there is no proper load signal, so that's about all it can do. My suggestion? If you don't want to go full aftermaket ECU, then get some R35 GTR AFM cards and some housings to put them in, in the stock location, and Nistune the ECU. Better to do a good upgrade than just replace shitty 40 year old tech with the same 40 year old tech.
    • So my car was recently having trouble starting on initial crank, I would need to feather the gas for it to start up but besides that it would start and run fine. So I clicked the idle air control valve (with throttle body cleaner) and cleaned the MAF sensors (with MAF cleaner). The start up issue was fixed and now the car turns over without the assist of the throttle, but the car is in limp mode and wont rev past 2.5k RPM. From what I understand the IACV would not put the car in limp mode, so I am to believe it is the MAF sensors, but it was running fine before and now I cant get it out of limp mode. I cleaned the MAF made sure the o rings were seated properly. Made sure the cables were plugged in properly, the cables also both read the same voltage. Does anybody know why this is or what could be causing this or how to get it out of limp mode?
    • Ooo I might actually come and bring the kids, however will leave the shit box home and take the daily
    • Thanks. Yeah I realised that there's no way I'd be able to cover the holes with the filler, it would just fall through. Thanks again @GTSBoy!
    • That was the reason I asked. If you were going to be fully bodge spec, then that type of filler is the extreme bodge way to fill a large gap. But seeing as you're going to use glass sheet, I would only use that fibre reinforced filler if there are places that need a "bit more" after you've finished laying in the sheet. Which, ideally, you wouldn't. You might use a blob of it underneath the sheet, if you need to provide some support from under to keep the level of your sheet repair up as high as it needs to be, to minimise the amount of filler you need on top. Even though you're going bodge spec here, using glass instead of metal, the same rules apply wrt not having half inch deep filler on the top of the repair. Thick filler always ends up shitting the bed earlier than thin filler.
×
×
  • Create New...