Jump to content
SAU Community

Recommended Posts

i found a whiteline rear camber kit on ebay an im gonna give it a shot an see if a can get any better traction, but i dont fully understand how the kit works could you give me a rundown?

Instructions are in the kit.

Cheers

Gary

I used to drive around on semi's all day and every day.

they are legal for on the road as far as i'm aware, as they are dot approved,

in the wet, it was often hard to lose traction in a 450hp gtr And in the dry... forget about spinning your wheels anywhere, even 7000rpm launches all you got was stick.

Now the bad points,

They will be alot harder on your drivetran, you could possibly even break things, your diff is going to get a worn out alot quicker and the tyres themselves dont quiet last that long..

this was bridgestone re55s or similar.

dot approved is american

we are adr approved

I used Toyo Ra1's which are a excelent tyre for the street but yeah expensive, $400+. Similiar tyre i beleive to the Re55. Traction was great, didnt need to much warmth, and produced good Et's on the strip.

Negatives where noisy, picked up stones, wear too quickly etc. Positives, traction traction and more traction, gripped like a 4wd. Now im trying falkens RT615, definately not as good, but where a cheaper option..

personally i have used a few tyres on the street i have a set of toyo proxies 4 on my car atm and am very happy with them for the price they seem to perform well in the wet and in the dry but they may as well be made outta concrete compared to the toyo proxies r888 i have had on my car (very exspensive semi slick) they worked unbelivably well in the dry at very low temp and at very high temps and as for the wet that is where i think the big difference comes in, i used them on a very wet road one night having a bit of fun with a mate in similar cars, but i have bout twice the power of him i was only just loosing tracion in 2nd gear and had no understeer at all and soon could not see him behind, he said could not get the power down and was understeering like mad(he had the proxies 4 on his car) we have since done simliar things in similar conditions and now that my car has road tyres on it we are about the same pace. after all the only part of your car that touchs the road is the tyres. but after all that they do wear out very quikly and cost a lot of money but they are definatly worth it for performance driving and if the wet is the only thing stopping you then get them lol

I wouldnt say NEVER run a semi slick on the road. Yes you do need to be careful if the tyres are cold and more so if the roads are cold due to a cold day, but once youve driven a bit the tires do get enough heat in them to perform well, and from there if your driving spirited you reap the benefits of the extra grip.

I ran re55's all round and loved them, but i did have one bad understeer event due to an afforementioned cold condition.

Of course if your daily driving it then theres not much point, but if you have lots of power and like to go for a good hard drive more than once in a while then they are awesome.

As far as stiff sidewalls, noisy, and harsh ride goes, well for me these things are not a concern, how it goes/handles/stops takes priority.

Try them once and determine for yourself, just get a feel for how long it takes to warm them up. Take it out on a warm sunny day and a gentle drive on the hot tarmac will heat em up no worries.

Very high road noise..

Scary as F*ck in the wet..

High cost..

They wear down quite quickly..

But at the right time and place.. it all makes sence.. Their just brillient to drive on!

Getting tyre press is also key in the way they handle. Pressures can be quite hard to get right aswell.. alot of trial and error..

Edited by GTS4WD
dot approved is american

we are adr approved

This is a good point...

"DOT" (Department of Transport) is American, this is the industry standard for tyres in the USA... If a tyre has been developed for sale in America and has been approved by DOT then it is legal for U.S roads.

You may also see "E-MARK" on a tyre sidewall, this is the equivalent of DOT in Europe.

"ADR" (Australian Design Rule) is obviously Australian, however ADR's do not apply to aftermarket tyres sold in Australia, there is no industry standard or method of pre-sale testing here, therefore as long as a tyre that is sold in Australia complies to the load and speed index recommended by the vehicle manufacturer it can be used legally on our roads.

The reason that DOT and UTQG are so important is so that you know that the tyre you are buying has been both US Government and independantly tested and approved for American roads, this gives you the best indication as to whether you are buying a quality tyre or not.

If you have bought a tyre that does not have DOT, UTQG or E-MARK printed on the sidewall then you know that it cannot be sold for legal road use in the USA and possibly even Europe.

Overall youre best off sticking to tyres that have a DOT and UTQG rating. :D

Don't use semi slicks on the road.

Why?

Because they are, in no particular order:

Noisy.

Stiff in the sidewalls which gives you a harsh ride.

Expensive.

Short lived.

Pick up every stone etc on the road & fire it into your paint.

And, um oh yeah A WASTE OF MONEY

A semi slick needs temperature to generate its grip properly. Other than driving like a complete fkwit on the road you will not generate these temperatures.

So you will never get the gain out of the tyre you wanted.

Just go and buy some good road tyres.

lol wel lucky for me i drive like a complete fkwit....

running Toyo RA1's discontinued, great semi slick n good all rounder...

neovas are semi slicks??

are u serious?? i didnt know that.. no wonder ive got massive traction even thou ive got 300awkw and now i can explain my mates awesome launches in his s15... he can out launch an sti and almost a evo 8 MR lolol

fkn neovas how much r they worth?? i need some

and no.. pilot sports are shit fkn tyres. had those on my rx7 in 275/35/18 trim... no traction

i ended up gettin some Eagle something tyres.. like 700 each.. those had mass traction :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Skyline R33 Series 2 sedan tail lights in excellent condition. These are becoming harder to find, especially in this state.    BOTH SETS ARE IN FANTASTIC CONDITION (REFER TO PHOTOS)    ✅ No broken covers or cracks ✅ Lenses are in flawless condition ✅ All rear mounting lugs intact ✅ Comes complete as pictured ✅ Perfect for restoration, replacement, or upgrade   These lights are ready to go, no surprises just quality OEM parts.   These are definitely one of the better sets we have seen in a while. With minimal wear and tear they will come as you see. Bear in mind they are not brand new they are almost 30 years old now. To find them in this condition isn’t easy they can only be obtained on the second hand market.   Australia Wide Postage Available At Buyers Expense. Silver Set:$850 Grey Set:$850 PM Me for purchase or any other questions  IMG_2166.dng IMG_2165.dng IMG_2172.dng IMG_2173.dng IMG_2174.dng IMG_2179.dng IMG_2180.dng IMG_2260.dng IMG_2258.dng IMG_2259.dng IMG_2261.dng IMG_2266.dng IMG_2273.dng IMG_2274.dng IMG_2276.dng
    • Unsolicited advice? Keep the engine as close to stock as you can. Nothing wrong with adding some boost and making a little more power, but given where you are, you really don't want to try to make it into a monster. I can't imagine the roads are up to it, and the lack of locla support when it grenades will be a ball ache. FWIW, If there is a dyno around that you can access, then brand new injectors are a good idea, which will lead you to (at least) putting a Nistune in it, which will allow you to put an R35 AFM on it, all of which will make it possible to make it much much nicer to drive and live with.
    • List all of your mods. It sounds like an aftermarket ECU hitting rev limiter. Like a valet mode, or a cold rpm limiter? 
    • @Kapr Haha yeah thats the one. I missed that you had a built up engine, I wouldn't want to run it on there either then. It was good in my situation just to replace the original turbo on a stock engine. @MBS206Yep definitely not a replacement for anything name brand
    • You are selling this? I have never bought something from marketplace...i dont know if i trust that enough. And the price is little bit "too" good...
×
×
  • Create New...