Jump to content
SAU Community

Recommended Posts

  • 2 weeks later...

Fired it up this morning.

(typical crap sound quality due to engine noise)

It's all untuned and just running on the start-up mode, hence the big lumpy idle. It wont take throttle yet, but at least it runs under it's own steam.

What ID are the toyota throttles?

42mm.

The tune on Thursday will just be a temporary measure, so that I am able to run the car at a test day on Monday to find all the problems before going to the final tune and dialing up the cams fully. Just want to be able to turn the wheels again, been a long couple of months.

I have to ask, with your choice of ECU, does the Link do a lookup comparison between MAP and TPS?

With ITB, you'll find that at different throttle positions, you get the same pressure behind the throttle body (Headed for the motor) but, you're actually getting different air, especially since you get a lot of air turbulence.

This is where you'll LOSE out on your throttle response, and get a drop in power, if it's not able to be tuned properly.

The Adaptronic which was mentioned earlier, does exactly this. The GTR doesn't have to worry about anything of the likes until you go MAP sensor on it. And then it sees the exact same issue.

Also to the person saying the Adaptronic runs unreliable drivers... I'd like to ask, SINCE WHEN?

Just a quick update. No pic's/vid's at the mo, haven't got time.

The car is up and running. Has much more torque, good throttle responce and sounds awsome!

Ran the car at two gravel hillclimbs on the weekend and found the extra torque very usable off the turns.

My mate is currently making some longer trumpets based off the info from the dyno run. This will mean we can dial in a wider power band from the cams and complete the tune. In the meantime I'm jut getting on with racing the thing again.

  • 1 month later...

I've done a few events with the ITB setup now and I have been very impressed with the results.

The car pulls much stronger in the mid-range, which is where I need it and it still rev's out easily to 8k. The throttle responce mid corner is instant and I am able to use more control when I'm looking for grip and there are no flatspots anywhere in the rev range from 3500rpm on.

The video below is of a steep hill we ran up a couple of weeks back. Compared to last year, I found it far more driveable and easier to keep momentium.

http://nz.youtube.com/watch?v=pjSTmw_WWqs

Still more tuning to be done, so hopefully with a few adjustments I'll have a wider powerband to play with.

picture001smlzy8.jpg

Edited by screamin'
  • 3 weeks later...

What power did it end up making and what torque?

Do you have a dyno graph?

Sounds really nice, good to see people doing something out of the mainstream and the engine bay looks really neat.

Don't have figures for the torques or ponies, wasn't too fussed about that and at the end of the day numbers don't mean much on gravel.

It has great midrange torque for a 2ltr and this makes the car far more drivable and controlable through the corners, when compared to the same events last year.

Why would itb's be illegal, unless you guys have some emission controls or something over there, which means in that case my SS is illegal too.

After the first event the engine bay is now really dusty, so it didn't look that good for long!

  • 4 months later...

Been running it for a while now. Car is going real good, had a couple of 1st in class (1600-2000cc) and a 1st two wheel drive on one hill climb. Good to be beating the Escorts and Tereno's.

Got a couple of short vid's of last weekends rallysprint. Day started off at -5°C and didn't get much warmer!

Some photo's. Check out the frozen road!

http://www.colourandlight.co.nz/galleries/...ne09/index.html

  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I’m not sure what happened I told them about sonic tunes free OTS tune and the next the I know .. I was booted..   To funny 
    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
×
×
  • Create New...