Jump to content
SAU Community

Recommended Posts

 

for $10 more I would be going for the full zinc Racing 10

http://www.penriteoil.com.au/pis_pdfs/010%20TENTHS%20RACING%20OIL%2010%20NOV%202012.pdf

 

I bought the 10 Tenths Racing 10 in a 20l drum for about $120.

Trouble is...

I can't remember if it was on this F/S forum or the OzFoz F/S forum - sorry

For normal service intervals on a road going car, the enviro 5w-40 would be a far smarter choice than the 10 tenths racing. Reason being that 10 tenths is ester based and only designed for short service intervals (one change per race day) and has a dreadfully short effective lifespan. I'm pretty sure it also doesn't meet or exceed any of the last 3 or 4 API ratings...

For normal service intervals on a road going car, the enviro 5w-40 would be a far smarter choice than the 10 tenths racing. Reason being that 10 tenths is ester based and only designed for short service intervals (one change per race day) and has a dreadfully short effective lifespan. I'm pretty sure it also doesn't meet or exceed any of the last 3 or 4 API ratings...

That sucks :(

Is Mobil 1 0w-40 okay to use in a non turbo r34?

Bit thin, try 5w-50

That sucks :(

Bit thin, try 5w-50

There is some truth in what he said there in that racing ten doesn't have the latest ACEA ratings like A4 A5/B5 like the Enviro but the rest is complete BS.

Racing 10 does have high zinc (ZDDP) which is good for RB engines especially Neo's and RB26's with solid lifters, oils with high zinc and phosphorous levels tend to clog catalytic converters faster and hence they don't meet the latest standards for petrol/ diesel economy engines designed to run in California with their strict laws.

It's service life is fine for daily driving, hence it's A3/ B3 rating...

For use in high performance petrol and diesel cars and light commercials where extended drain intervals are specified by the vehicle manufacturer and / or for year-round use of low viscosity oils and / or for use in severe operating conditions as defined by the vehicle manufacturer.

...probably one of the better oils to use in an RB!

Edited by Missileman

On my GT-R I went from HPR10 to SIN5 to Racing 10 (couldn't find Premium 5). The 10 tenths made the most noticeable difference, the engine runs smoother and quieter compared to the other two oils. Hopefully they last 10,000km lol.

TJZ - 10W-40 is not too thick, Nissan 200SX oil (from Nissan) is 7.5W-30, so 10W-40 or thereabouts is fine for daily driving. If you're thrashing your car a lot then look at getting thicker oil (5W-50 or 10W-60 etc.).

There is some truth in what he said there in that racing ten doesn't have the latest ACEA ratings like A4 A5/B5 like the Enviro but the rest is complete BS.

My apologies, I was about to start ranting and raving and calling you names when I thought I'd better check the Penrite website. It appears as though the formulation has been updated since I left the industry and now complies with the latest API (SN) rating AND they've done something about it's service life.

This will actually make my next oil change a difficult decision as I always like the ten tenths range based on its other benefits (friction/cleaning) :)

Thanks for the heads up (even if it was a little blunt)...

That's OK. It takes a man to update; even if it conflicts with previous info supplied.

One of the Z-Tunes in Oz was run on Elf Excellium SC 5W-40 which I then ran in my previous VS2.

I didn't have it long enough to see incremental changes at each oil change.

no apology necessary, some times i'm blunt, some times i'm sarcastic, a lot of the the time i'm just plain rude, i put it down to old age.

oh and I'm not trying to push penrite, in fact i've never used it, though i may give it a try next change.

That's OK. It takes a man to update; even if it conflicts with previous info supplied.

One of the Z-Tunes in Oz was run on Elf Excellium SC 5W-40 which I then ran in my previous VS2.

I didn't have it long enough to see incremental changes at each oil change.

I'm surprised they don't use something like Mainlube in such a rare motor!

I'm surprised they don't use something like Mainlube in such a rare motor!

Yeah, well it went off to Greece.

Probably not worth much under it's economy; but perhaps it can be resold in a richer country.

Back to thread, that Z-Tune was being serviced here in Sydney by an RB specialist.

The penrite 10 tenths is good stuff. I've used the Penrite racing 5 oil (now 10 tenths) since I got my old ford laser years ago with about 250,000k's on the clock. It's now done near 360.000k's and it's still going strong despite being given some hefty punishment over the years. I used to do changes every 10,000 but it's down to about 5-6000 now because it slowly gets noticeably more sluggish and rough after that in it's old age.

I've been using Penrite since I started driving. HPR15 in my R31 for 5 years no issues.

With my GT-R, went from Mobil 1 5W-50 to SIN5, engine ran noticeably smoother and the pressure was more consistent at 5,000 km compared to fresh oil. The 10 tenths is even smoother again (by not much).

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Ahhh, I need the whole head unit. I definitely needed to roll back through and review your setup, ha ha! Neat setup they have going on. I just need a full double din head unit. But I want good and responsive. I might have to review what the likes of pioneer have out these days.
    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
×
×
  • Create New...