Jump to content
SAU Community

R34 Gtst Stage 1 Tuning, Video ..

Torques

By Torques,
in Forced Induction Performance

 Share

Recommended Posts

Torques Mentor

Torques

Posted
Posted (edited)

Hello there,

I came across these videos.

It shows an R34 upgrade using larger exhaust, intercooler, and finally boost level (boost controller) upgrade.

After each mod it goes to the dyno, results are shown.

I found this quite interesting, so have a peek:

Skyline R34 Stage 1 Video/Dyno

You need Windows Media Player and a good internet connection.

I was tired of rubber stamp sized videos, so I encoded the video in a decent size.

Cheers :P

Edited by Torques
Link to comment
Share on other sites
Wacky Dee Veteran

Wacky Dee

Posted
Posted

did the stock turbo blow up at 12psi ?? I've been running my stock GTT at approx. 12 psi for more than a year now hmm... Well I don't really hit 12psi that often as I rarely gun it above 5000rpm but still, a bit of a worry especially since that crap can end up inside the engine and not just the cat..

Link to comment
Share on other sites
  • 2 months later...
Torques Mentor

Torques

Posted
  • Author
Posted (edited)
Quite like videos like this.

Yep, far too less of this kind around.

It's no nonsense with proper before and after dynos ...

I have updated the page for the video, now showing 2 more stages ... however there seems to be some kind of network problem.

The sound stutters at times ... I might have to upload it again.

R34 GTT Stages

Edited by Torques
Link to comment
Share on other sites
Aaron Hazard Apprentice

Aaron Hazard

Posted
Posted

Nice Post, realli helped me Tuning my GT-T; jus a few annoying questions =p, What Exhaust Manifold Did the HPI car use? and not sure they tell you in the hpi video but how did u get those aftermarket gauges to fit in the stock center guage pod!?!? need to replace mine =D. THanx and Thanx heaps for teh vids!

Link to comment
Share on other sites
gotRICE? Veteran

gotRICE?

Posted
Posted (edited)
Yep, far too less of this kind around.

It's no nonsense with proper before and after dynos ...

I have updated the page for the video, now showing 2 more stages ... however there seems to be some kind of network problem.

The sound stutters at times ... I might have to upload it again.

R34 GTT Stages

Sound was good on Stage 3 , but the video was horrible, like 1 frame a second :) Cleaned up at points.. but not very nice to watch :P

Same with Stage 4. Video is really bad but sound was good. The picture is clear, but not smooth, ya know.

Maybe try again, im knee to see.

Edited by gotRICE?
Link to comment
Share on other sites
  • 2 weeks later...
Torques Mentor

Torques

Posted
  • Author
Posted

Hello there ...

I have made a new attempt at the videos.

It's not perfect but seems to be working (at least on my side of the globe:)).

Please let me know if you have any stutter or playback issues.

It's best viewed with Internet Explorer it seems .. (sorry about that)

Here's the link:

R33 GTST /34 GTT And Related

Link to comment
Share on other sites
MasterShake Apprentice

MasterShake

Posted
Posted
Hello there ...

I have made a new attempt at the videos.

It's not perfect but seems to be working (at least on my side of the globe:)).

Please let me know if you have any stutter or playback issues.

It's best viewed with Internet Explorer it seems .. (sorry about that)

Here's the link:

R33 GTST /34 GTT And Related

They look good on Firefox for me.

Great videos.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Therry
      Pre purchase inspections

      By Therry · Posted

      I'm in the market for 370GT.  I live in Canberra and not much available so I'm looking interstate.  Can anyone recommend an inspection service with expert knowledge of Skylines? Sydney, Melbourne and Adelaide (Elizabeth area)
    • GTSBoy
      High EGT mystery

      By GTSBoy · Posted

      A million years later, searching for something else I posted, I was reminded of this thread. I eventually bought a new gauge. Put it in using the same probe (which has been installed the whole time stopping the exhaust gas from coming out the hole) and.... normal service has been resumed. The old gauge was definitely broken. /semi-pointless closure.
    • Kinkstaah
      Dose's Sometimes DIY and Pay Someone Home & Boat Improvement Thread

      By Kinkstaah · Posted

      They're available from Nissan! I was able to buy a GTR (R33) one.. relatively* recently. Perhaps this stopped now but I bought mine ... relatively recently. I believe the 300ZX one has a different knee-point which is more rear biased, which I think the HFM one echos.
    • MrCodZilla
      370GT ( Type SP ) - Sedan - Cruise Control - Forced Induction - EcuTek

      By MrCodZilla · Posted

      Hey Team, A bit to unload here. Hello from New Zealand I have a 2009 Nissan Skyline 370GT ( Type SP ) Auto 7 Speed, that I've had since 2022 and have loved the car since. Its painted in its factory QAB ( White Pearl ) with the Impul front lip and rare boot lid/spoiler with woodgrain interior. Mods since I've bought it and installed: Stillen Gen 3 Long Tube Intakes Motordyne Shockwave Catback Exhaust JDM Skyline Taillights Fake carbon spoiler and front grill ( Will be taking off.... its cringe ) VR30DETT Transmission from the Q50/Q60 to hold up to 550 Foot pounds of Torque ( 753 nm ) reliable  Currently I plan to turbo the car and have all the parts needed ( Photo Included ), I have my tuning day set on August 8th and choosing EcuTek as my tuning platform. Two of my work colleagues has their 370Z ( Manuel ) and 370GT coupe ( Type SP - Manuel ) also turbo'd and they have inspired me to get it done I have prepped quite a wee bit for this, as I had done the VR30 transmission swap over to this car so that I can achieve my HP goals without torque being an issue. I've taken quite a cautions route, as im always thinking about the safety as well as performance with my build, I'd rather do it properly and not cut corners etc etc. Any who, I've recently picked up the AutoStrada cruise control kit with all the included cables/wires/instructions. I've been hella researching around and can't find much on the integration that it has with the ECU and/or system. the only reason why im asking is, because I'm getting EcuTek and one of them RaceRom features allows the ability to switch maps via the cruise control function, which I am currently in the grey area if this would add-on via the Canbus will allow me to switch maps or have the option to use Cruise Control to begin with ( showing up on the instrument cluster to advise Cruise Control being set etc etc )  Because of my model being Type SP, Cruise Control on these models was never an option from factory unfortunately.  Anyone here that is able to shed some light on if the Cruise Control via AutoStrada gives OEM ability over the cruise control. Would love and appreciate any response and/or assistance with this, also happy to answer any question about my build and ill try pitch in where I can. Warm Regards,  
    • GTSBoy
      Dose's Sometimes DIY and Pay Someone Home & Boat Improvement Thread

      By GTSBoy · Posted

      I thought the only (new) BM57 that was readily available was the one that was a BM57 but with the wrong bias. HFM or someone's?
×
×
  • Create New...