Jump to content
SAU Community

Recommended Posts

Spotted two Skylines in the space of 100metres and less than 5 seconds - one was a silver R33 GTSt reversing out of a driveway on Fitzwilliam Rd in Toongabbie, and the other was a black R32 GTSt turning left off Fitzwilliam Rd and into Tucks Rd.

Spotted 2 nice white R33s within about 2 minutes of each other at 11:45am travelling down Roberts rd near punchbowl, greenacre. 1 waiting to turn onto Roberts, either a GTR or trust front bar and GTR wing and the 2nd heading towards Hurstville way, GTR wing with a black blade and what looked to be a trial rear bar. Nice cars if you're on here. :D

You should have stopped and found out! :P

You should always look after fellow import owners, especially if they're in the same car as you :action-smiley-069:

I think that might be e-dog on here too, not certain though...

It wasn't that easy. I was in the far right lane, in heavy traffic, and I spotted him pulling into the hard shoulder on the far left just as I was driving past. Not the easiest thing to get over three lanes into the shoulder and pull up during in peak hour.

iam a truckie, i work down in canberra and spotted R33 GTR BCNR33 plates i think it was.. white one

then also an R34 GTR as well as the powerplay imports nissan navara ute

following soon after on the hume highway heading towards canberra..

round 7.00 last nite

very nice looking cars, must have been heading to wakefield or sumfing

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...