Jump to content
SAU Community

Recommended Posts

Spotted two Skylines in the space of 100metres and less than 5 seconds - one was a silver R33 GTSt reversing out of a driveway on Fitzwilliam Rd in Toongabbie, and the other was a black R32 GTSt turning left off Fitzwilliam Rd and into Tucks Rd.

Spotted 2 nice white R33s within about 2 minutes of each other at 11:45am travelling down Roberts rd near punchbowl, greenacre. 1 waiting to turn onto Roberts, either a GTR or trust front bar and GTR wing and the 2nd heading towards Hurstville way, GTR wing with a black blade and what looked to be a trial rear bar. Nice cars if you're on here. :D

You should have stopped and found out! :P

You should always look after fellow import owners, especially if they're in the same car as you :action-smiley-069:

I think that might be e-dog on here too, not certain though...

It wasn't that easy. I was in the far right lane, in heavy traffic, and I spotted him pulling into the hard shoulder on the far left just as I was driving past. Not the easiest thing to get over three lanes into the shoulder and pull up during in peak hour.

iam a truckie, i work down in canberra and spotted R33 GTR BCNR33 plates i think it was.. white one

then also an R34 GTR as well as the powerplay imports nissan navara ute

following soon after on the hume highway heading towards canberra..

round 7.00 last nite

very nice looking cars, must have been heading to wakefield or sumfing

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...