Jump to content
SAU Community

Recommended Posts

Hi Guys,

I think I need a new battery for my car dude.

When I go to start it sometime it will just tick once and not even crank over.

And also it seem like it is strugglying to start once it starts cranking.

My questions is has anyone changed their battery before for a R33 Skyline?

What type/brand is good and what sort of rating is needed for a Skyline.

I don't know much about car batteries beside that is starts the damn thing :D

So any advice would be helpfull.

Also how much are they usually? I have seen some that are in their $100 to some that are close to $300 bucks?!

Thanks

Link to comment
https://www.sau.com.au/forums/topic/29501-new-battery-help/
Share on other sites

Yes changing the battery is simple and has been covered before. Try a search.

But basically you need to make sure the battery you buy as a replacement needs to be approximatly the same size as your existing one to fit in the tray and not be too tall as to intefere with speakers or such. It also needs to have quite small terminals to fit.

Since it is in the boot the battery should be a sealed type, also known as maintenance free. It should not have caps that can be opened to replace water.

You can pick one up from $60 and up.

Link to comment
https://www.sau.com.au/forums/topic/29501-new-battery-help/#findComment-603057
Share on other sites

Hi

I had to buy a battery as well about two days after I got my R33. The previous owner hadn't driven it much for over 3 months.

Anyway - I bought an Optima D51L - cost a FORTUNE - $315 - but that included over half an hours labour cos - and here's the important bit - the previous battery was just your STANDARD car battery, therefore unsealed and the b..... thing had spat watery acid c... EVERYWHERE and the guys at battery place had to strip EVERYTHING out and wash it all down with soapy water and bicarb...

Also the old battery only had 280 cold crank amps which apparently was no good for anything....

So the moral to the story is to ALWAYS (as mentioned in a previous post) put a SEALED battery in the boot of a car. I live in Canberra and apparently here in the ACT it is illegal to have an unsealed 'normal' car battery in the boot of a car.

Also make sure you get a battery with decent cold crank amps. This new one has 500 cold crank amps. AS I said in a similar post a month or so ago which I think got lost in the forum 'death' - my car almost starts without me turning the key!!!!! :cheers:

Hope this helps :O:cheers::worship::worship:

Link to comment
https://www.sau.com.au/forums/topic/29501-new-battery-help/#findComment-603512
Share on other sites

Mine came over with a crappy jap battery that only lasted about ten cranks before dying.

I went and bought a Yuasa battery. Get the dude that you're buying off to check that the terminals will fit and that the footprint fits into the existing holder. Mine has a capacity of 425 CCA (I think) and it cost me around $130.

Best money ever spent.

Link to comment
https://www.sau.com.au/forums/topic/29501-new-battery-help/#findComment-605733
Share on other sites

Yeah I went down to some battery place where they had a battery that will fit the Skyline R33 along with the right size terminals. It cost $99 bucks but I think it is only like a 380CCA.

Does that matter? Like i'm not running any big ass system or anything. Just want it to start well and last long. My current battery now goes flat if the car is not started in 3 days!!

Link to comment
https://www.sau.com.au/forums/topic/29501-new-battery-help/#findComment-608223
Share on other sites

check your ground wires before you change your battery buddy. mine use to click sometimes and not even turnover. turned out the battery wasnt charging because the ground wire in the engine bay was dirty. Car starts in 1-2seconds now with no trouble at all. Check your voltage at the alternator and then at the battery to see if theres much difference.

Link to comment
https://www.sau.com.au/forums/topic/29501-new-battery-help/#findComment-608444
Share on other sites

Don't know how old the battery is as it was already there when I got the car, but i'm guessing that it came over from Japan as all it has is japanese writting and it is a Panasonic?!?!

Are these the original battery the Skyline came out the factory with?!

I think it is charging, after a jump start and driving around for 15-20 things are normal again.

It is a weird glitch, as it only happens sometime when it will just tick and not crank. But now I have notice the car is taking longer to crank over.

Link to comment
https://www.sau.com.au/forums/topic/29501-new-battery-help/#findComment-609519
Share on other sites

The battery that was in mine had Skyline R33 written on it, I just changed mine I got a Delkor 22F610D and got the terminals and the leads changed.

Have a look here...http://www.skylinesaustralia.com/forums/sh...ead.php?t=28697

Link to comment
https://www.sau.com.au/forums/topic/29501-new-battery-help/#findComment-610672
Share on other sites

I converted mine to an Odyessy total seal. I can get them in the country areas. I tried and couldn't get the Yuasa battery [it was a jappa batt, even Yuasa Aust. said no go].

I had to change my leads etc, and weld up a new battery holder setup, did it all myself and ended up with a top shelf job [if you want it done right......do it yourself].

The Odyessy battery is a queer animal, nil maintenance, long life, and big crank power, they are a bit more exy though.

Link to comment
https://www.sau.com.au/forums/topic/29501-new-battery-help/#findComment-613186
Share on other sites

400a for the 800amp, and 600a for the 1000amp [i think I've got an 800, I'll check on that, but it has a few other other attributes that are supposed to make them the 'ducks guts' of batteries.

Have a look on their web site [assuming they got one] or get a pamphlet. It will explain it heaps better than I can.

It rapid recharges after heavy load, has a big cycle rate, can be deep cycled, long shelf life, etc etc

Link to comment
https://www.sau.com.au/forums/topic/29501-new-battery-help/#findComment-613728
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Welcome to Skyline ownership. Yes, it is entirely possible parts websites get things wrong. There's a whole world of inaccuracies out there when it comes to R34 stuff (and probably 33 and 32). Lots of things that are 'just bolt on, entirely interchangable' aren't. Even between S1 and S2 R34's. Yes they have a GTT item supposedly being 296mm. This is incorrect. I would call whoever you got them from and return them and let them know the GTT actually uses 310mm rotors. Depending on where you got them from your experience and success will obviously vary.
    • Hi...a bit a "development" on the brakes. I spoke to the guys where i get brakes from...and they are saying that 296mm EBC are for R34 GT-T. I then went to their site: https://www.ebcbrakes.com/vehicle/uk-row/NISSAN/Skyline (R34)/ and search for my car(R34 GT 1998 - it has GTT brakes) and it show me this USR1229 number and they are rly 296mm rotors... So now iam rly confused... The rotors i have now on the car are 310mm asi shown... So where is the problem? Does the whole EBC got it wrong or my calipers are just...idk know what?  
    • Oh What the hell, I used to get a "are you sure you want to reply, this thread is XX months old" message. Maybe a software update remove that. My bad.
    • This is a recipe for disaster* Note: Disaster is relative. The thing that often gets lost in threads like this is what is considered acceptable poke and compromise between what one person considers 'good' looks and what someone else does. The quoted specs would sit absurdly outside the guards with the spacers mentioned and need  REALLY thin tyres and a LOT of camber AND rolling the guards to fit. Some people love this. Some people consider this a ruined car. One thing is for certain though, rolling the guards is pretty much mandatory for any 'good' fitment (of either variety). It is often the difference between any fitment remotely close to the guards. "Not to mention the rears were like a mm from hitting the coilovers." I have a question though - This spec is VERY close to what I was planning to buy relative to the inboard suspension - I have an offset measuring tool on the way to confirm it. When you say "like a mm" do you mean literally 1mm? Or 2mm? Cause that's enough clearance for me in the rear :p I actually found the more limiting factor ISNT the coilover but the actual suspension arms. Did you take a look at how close those were?
    • @GTSBoy yeah sorry i know thery are known for colors bud those DBA are too in colors 🙂 Green will be good enough for me  
×
×
  • Create New...