Jump to content
SAU Community

Recommended Posts

he he i set a cars alarm off in dickson last friday..

and then some stupid bloody pedestrians walked out on the zebra crossing in front of me.. what the hell!! i was driving there!! did they want to get hit??

in my pervious car, a BMW, i used to set car alarms off with my stereo :D

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/604/#findComment-5048652
Share on other sites

Nice sig pic Shell!! :(

Thought it was about time I put my car in since i don't have any banners for events taking the spot atm!! :P

i spotted a white 32 gtr in homeworld today at around 2ish in my 33 then when i was in the vl i spotted a yellow 34 at the light where kambah high used to be both were very tidy looking cars

That would have been me... were you in the Walkie VL??

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/604/#findComment-5049309
Share on other sites

I could be wrong in my assumptions, but the owners of 34 and 35 GTRs in the area give the impression to me that they're too good for SAU...moreso, they give no impression at all, because while I am 99% certain they know of the website and forums, they never post or reply to spotted's...

ah well, such is life.

Hey! I take offence! I usually reply to posts of when I am spotted - though I am not on here that frequently as I'm too embarassed to look at the forums whilst I'm having troubles with my car. I think someone posted about it later on in this thread about my R34 blowing flames around DFO... gotta get her fixed!

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/604/#findComment-5060153
Share on other sites

Spotted r32 athllon drive near mawson gave a wave got one back, and purple 33gtr, white 32 with black bonet, white 33 and silver 34 near where I was parked in Woden area earlier

spotted purple r33 with gold rims near torrens/pearce, and could have been my silver r34 at woden parked underground on sunday

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/604/#findComment-5060693
Share on other sites

Spotted a white R33 at BP Phillip.. large islander(?) guy with fluro work wear top on

Then a red R33 in Fyshwick, I did see you wave at the last minute, and waved back but you probably didnt see!

Then bayside blue R34 GTR on Pirie Street

Then a white R33 in the Woden underground carpark leaving just ahead of me

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/604/#findComment-5060742
Share on other sites

Then a red R33 in Fyshwick, I did see you wave at the last minute, and waved back but you probably didnt see!

Also spotted a red R33 in Fyshwick, I waved, didn't see if she waved back. Saw a white R33 just up from woolies Conder, heading to Tuggers at about 6:15am.

Lastly a (I think white - can't remember) R34 heading into Hume from Queanbeyan at about 8am.

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/604/#findComment-5061165
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I was using the wiring diagram I have So 12.74V is coming into the rear Fuel Pump relay as I measured.  When I turn the key to ON im getting 0.6V to the Fuel Pump plug; which i assume is backfeed voltage and doesnt include the 12V from ignition power.  The rear relay is working and being triggered.  From the diagram I clearly see the rear relay 80 = Rear Relay going into the Body/H loom (R-27) 27 = Fuel Pump plug going into the Body/H loom (T-20) 40 = Short Connector (R-27) I'm reading 12.74V on the blue/black wire which is the power for the Fuel Pump   From this diagram I can see the Ignition relay goes into the front and up to the ignition  2 = Fuel Pump Relay <1M> (R-27) 37 = ING Relay <1M> I started from the pump using this reference Which the way I read it (referencing Nissan wiring color codes) is: Pin Wire Color Function 1 B/P (Black/Pink) Ground 2 L/W (Blue/White)        ECU Trigger 3 SB (Sky Blue) Fuel Pump 5 L/B (Blue/Black) 12V Constant Tested SB to SB on Fuel Pump for continuity - confirmed Tested negative on Fuel Pump to 12V battery and L/B - confirmed 12V Pulled the relay putting 12V between Pin 1 & 2 and testing continuity on Pin 3 & 4 - confirmed relay   So that has me looking at this part of the circuit to understand whats happening here...and im still confused. From best I can tell; the disconnect is back to my previous diagram; between Ignition Relay and Fuel Pump Relay...which yet again; afaik is where the immobiliser should.    Thats what I was trying to explain to GTSboy; im not trying to fix it myself; yet I seem to have to get a Masters in Electrical Engineering (while im busy doing my actual job of DevOps & Cloud Engineering) somehow.  I just wanted more expert opinions; or more so that what I tested is correct and proves it to something around that area; to go back to the alarm tech (for a 3rd time) that he needs to fix it. He keeps telling me its not the alarm. He lives on the complete other side of the city so i understand not wanting to make a trip but as I said before if its the alarm it should be up to him to fix it. But he's adament its not; even though I pointed out the FP was immobilised through the original alarm. To my mind; it seems that the ECU is sending the signal; but the ignition is not getting 12V down the line.       
    • Maybe also really stiffly sprung track cars. Get the inside wheel up in a corner and all the fun stops. Also me sometimes (rarely) when I have to stand on the brake to convince the diff to drive the wheel that is still on the ground when I'm trying to diagonally get over severe driveway entrance, etc.
    • I feel like I'm missing something. You had an authorised installer come out and install a new alarm. Post install the car doesn't start, and you aren't getting the installer back to fix what they did wrong?
    • So either way it is gearbox out and look what is wrong?  I know about the input shaft bearing. Even before swap/new clutch the it sounded exactly like this: So is that inout shaft bearing or the other was installed backwards?  And can some please tell me the part number for that input shaft bearing? The gearbox is small box from R34 N/A and number is FS5W71C. Thank you  
    • I am yet to see anyone ever regret a quaife or helical. ...other than drifting/skidpan duties. I kind of want to upgrade my factory helical with a Quaife (but really it's not ultimately that different, and is a MASSIVE UNDERTAKING), that's how good the hype is about them, that I want to try them 'just to see'  
×
×
  • Create New...