Jump to content
SAU Community

Recommended Posts

Spotted a black lancer with P plates on Hindmarsh near Kambah village obviously in a rush....protip: if you want to drive like a f**king tool, at least get a car with the balls to do so. Dropping the clutch like you're dragging me and then being mashed like a little girl before you even find the speed limit must have made your bangin' hot girl in the passenger seat wet as all f**k yeah? ;)

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/694/#findComment-6071259
Share on other sites

lol^^

I got reminded why I didnt get a v8 snoarer on the way home.

one over took me on drakeford and planted it...it made lots of noise and very slowly went past...I loled

Hahaha!

I had a dude in some ugly looking thing I couldnt even tell what it was do this to me.

He pulled up at the lights and just sat there staring and rolling forward.

He then took of doing 0 - 60 in 40seconds flat

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/694/#findComment-6071655
Share on other sites

Spotted a black lancer with P plates on Hindmarsh near Kambah village obviously in a rush....protip: if you want to drive like a f**king tool, at least get a car with the balls to do so. Dropping the clutch like you're dragging me and then being mashed like a little girl before you even find the speed limit must have made your bangin' hot girl in the passenger seat wet as all f**k yeah? ;)

i always drag race people in my 0-100km/h in 2minutes car because that way i feel like i won when i full throttle and barely manage to reach the speed limit before they do while they dont even know im trying to race them :P

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/694/#findComment-6072495
Share on other sites

i always drag race people in my 0-100km/h in 2minutes car because that way i feel like i won when i full throttle and barely manage to reach the speed limit before they do while they dont even know im trying to race them :P

exactly this. hahaha

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/694/#findComment-6072524
Share on other sites

Spotted Zane and Mel yesterday, I tried ghosting them Hamish and Andy style them in the supermarket but they caught on :D

Also spotted a black R33 today about 2pm on the Monaro where it goes over Canberra Ave.

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/694/#findComment-6076846
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
    • This looks great! Awesome to have the 5 speed with an LSD in this. The Recaro's look like SR2's or SR3's. It's a shame they've been retrimmed as they would have looked sweet in their original colours. I think I'd want my agent to be a little more up front and informative too. I've never imported but I reckon it would make me a little nervous, so the more info the better.
×
×
  • Create New...