Jump to content
SAU Community

Recommended Posts

considering the showie nature of his car doubt he going to pop rivet into his rear bar

then he's doin the right thing by not running a decat.

if you're gonna do it, go double the fist and do it properly. the only thing that a cf heat shield will retard is your bank balance.

Haha aliminium sheeting to protect bar... But your putting holes in it :D defeats the purpose

would rather have a few small holes than a massive burn

my car shoots massive flames.. it IS a 989fwkw monster after all :(

Cataylic converters is for homosexuals.

Real man runs cat-less...

I just let the black soot build up on bumper and tell people 'it adds character'

My car shoots flames all the time and my bar doesn't get burnt. Just all the carbon build up makes the bar black
If it doesn't burn your bar.. just polish it more often? The shields look ghey.

I'm tossing up whether or not to punch mine out

+1 to this. My paint is fine :)

it is gay...thats why its not in my list of phone i can consider to get for myself soon..

what did u end up choosing?

tbh, i would go into a store and test them both, jbhifi has the htc desire to test

are you gonna buy outright? you going with telstra?

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
    • Legend. I ended up finding the facebook account of the owner of the first car i sent but sadly he deactivated the account. I think you’re right in saying it’s some sort of well done custom job. Really appreciate your help anyways.
    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
×
×
  • Create New...