Jump to content
SAU Community

Recommended Posts

Was an 'oh crap' moment, skipped a beat!! Lucky it was still hanging on the balancer. True Paul, you lost one too!

It's ready to go, just have to wait till Tuesday for tune booked in. I'm curious too, it's just linear on 14psi, I just want it to go well, butt dyno is the one I actually care about. Numbers are just that, numbers...

Meh, nah spent too much already!

Spat a power steering belt mid corner today on Putty Rd, scary moment!! Nearly crashed :( Needed to be retensioned anyways. Damn they are hard to steer with no power steering!!

what balancer are you using?

Ross balancer with powersteering under drive pulley.

Brand new belts stretch and need to be re-tensioned in my case....didn't retension soon enough.

Time will tell if it's something more commonly wrong or not. I've read the balancer thread.

Don't notice it. My knees don't bend the other way:)

Only if you put you feet right up to the base of the seat.

If it's a problem, I usually mount them on the passenger side.

Link to extinguisher bracket topic :Dhttp://www.skylinesaustralia.com/forums/topic/376435-cams-approved-fire-extinguisher-bracket/page__st__40__p__6621367#entry6621367

I see you're booked in tomorrow for a tune Sean!

Yeah if Yavus can get away from your car for just a few hours!!! :P

I also put in the crank trigger kit this arvo woot!!! It works fine, it's all coming together :D

Yeah if Yavus can get away from your car for just a few hours!!! :P

I also put in the crank trigger kit this arvo woot!!! It works fine, it's all coming together :D

mines going on the dyno in about 5 minutes. Just putting the airbox back on :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...