Jump to content
SAU Community

Recommended Posts

it was just clumsy on Hamilton's part (again!) - yes, at one point he was in almost to the front wheel, but then half backed out and the collision was Hamilton's front wheel on Massa's rear. Its not really an overtaking area - if you're going to do it there you really need to make it a dominant move, clearly in front. He didn't. His move relied on the other driver getting the f*&% out of his way. He had to know Massa was not going to do that!

On the other hand, I feel it was pretty deliberate from Massa - he definitely saw him going up the inside but gave him the big "f*&% you"

You know its a strange call when the pommy BBC commentators are amazed that Hamilton didn't get penalised.

Edited by hrd-hr30

I completely agree Harry.

I still see it as Hamo's fault. But would like to see some GPS data to confirm it.

To my mind, Hamo needed to be much more forthright to take that position cleanly at that part of the track, and he simply wasn't.

Massa's not liable to gift him the spot is he? It's a dubious passing spot, and if Massa WAS to yield, then I reckon he would simply have to go wide into the dust, and hence, understeer off the track!

To make any pass clean and successful, the passing driver needs to have the capacity to drive his own car, but also "get his brain" into the car he wishes to pass, and decide then if the pass can be made successfully! I think even Lewis would admit (if he were honest) that he didn't do that.

the correct call was made. their front wheels were nearly level and there's no way Massa could not have known Lewis was there.

You cant really believe that!

Hamo, "I am Lewis "Victim" Hamilton...i only need to be near the back of the car in front and I should be gifted a position"

I am not sure if Massa was a little later on the brakes or if Hamo knew he wasnt far enough up the side, he was on the dirty side, he had the wrong line...err basically he had ham fisted it and was trying to get out of there. Massa has to be the most hit guy in F1 this year. Between Hamoo and Webber in Monza...he is a magnet...it seems everyone thinks he is a soft touch, including Alonso

IF Massa did back out of the corner, or run right off the track (his only 2 options to avoid contact) I doubt Hamilton would've been able to make the corner himself. With that line he would've run wide..

I was speaking to a few Hamilton fans today and even they agreed it was bullshit.

The stewards penalized the wrong party.

Lewis is right on the edge of the track and Fillipe had the whole right side of the circuit and chops him anyway. Massa could have just missed the apex like he's supposed to when someone's attempting to overtake up the inside (and is well and truly alongside). Hamo obviously trusted him to leave some racing room, and what was he supposed to do about it when Massa just jags the wheel left at the eleventh hour??

The replay doesn't show an overly ambitious overtake attempt, I feel. The stewards no doubt saw the collision as avoidable if Massa had chosen to avoid it.

Lewis is right on the edge of the track and Fillipe had the whole right side of the circuit and chops him anyway. Massa could have just missed the apex like he's supposed to when someone's attempting to overtake up the inside (and is well and truly alongside).

yeah, see there's this thing called the racing line, that you need to take to make the corner at race speed. You can't just go wider and leave room without also going slower which he wasn't. Massa's only way through that corner at that speed was the line he took. This also suggests that Dezz's observation that Hamilton probably wouldn't have made the corner either is correct. And that's before you even take into consideration the dirty surface off-line. That's why the experienced drivers we have as commentators mentioned its one at a time through that section just one lap before.

Have since heard Hamilton admit in an interview he tried to pull out of the move. Half arsed passing attempt + half arsed pull out = complete Hamfisted effort. The guy's a hack.

Yep, I don't claim to be an experienced racer/race steward, but that was one of the easier calls imo. Not sure how they got it wrong to be honest...

As mentioned already, even Brundle and DC were saying Hamilton was to blame, and we all know how much they love to smoke his pole...

Lewis is right on the edge of the track and Fillipe had the whole right side of the circuit and chops him anyway. Massa could have just missed the apex like he's supposed to when someone's attempting to overtake up the inside (and is well and truly alongside). Hamo obviously trusted him to leave some racing room, and what was he supposed to do about it when Massa just jags the wheel left at the eleventh hour??

The replay doesn't show an overly ambitious overtake attempt, I feel. The stewards no doubt saw the collision as avoidable if Massa had chosen to avoid it.

With all due respect, and you've been around a long time, but I reckon we'd go a long way to find a bigger Lewi fan boy!

Martin and David were both astonished with the stewards decision in my opinion, but they need to bite their collective tongues.

He has had far too many run-ins with Massa this year. Lewis seems increasingly frustrated with being held up by Fellipe, and Massa increasingly annoyed at Hamilton's attempts to pass.

I think the best thing to say about the incident was LH's decision to come down the inside was a tad optimistic, and FM's defense was overly aggressive.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Ok i will get those 310mm. I found one but on a different site. This is the description on those...is it ok? Technical parameters: - Axle: front. - Disc type: ventilated. - Number of holes: 5. - Disc diameter: 310mm. - Total height with center: 54mm. - Thickness (new/min.): 30/28mm. - Designed for brake calipers manufacturer: Sumitomo.
    • You Gregged a whole racetrack!?
    • Look for broken wire or bad connector at the motor. Might not be it, but is worth starting there, as it is easy.
    • Hi everyone, I’m having an issue with my R32 GT-R. Sometimes, when the car goes over a bump or experiences some vibration, the 4WD warning light comes on the dashboard. When I check the code from the control unit in the trunk, it shows Code 19 – ETS Motor. However, everything seems to be working fine — if I turn off the engine and restart the car, the light goes away and everything functions normally. Has anyone experienced this before? Where should I start troubleshooting this issue? Thanks in advance!
    • I'm back from the dyno - again! I went looking for someone who knew LS's and had a roller dyno, to see how it shaped up compared to everything else and confirm the powerband really is peaking where Mr Mamo says it should. TLDR: The dyno result I got this time definitely had the shape of how it feels on the road and finally 'makes sense'. Also we had a bit more time to play with timing on the dyno, it turns out the common practice in LS is to lower the timing around peak torque and restore it to max after. So given a car was on the dyno and mostly dialled in already, it was time for tweaking. Luis at APS is definitely knowledgable when it came to this and had overlays ready to go and was happy to share. If you map out your cylinder airmass you start seeing graphs that look a LOT like the engine's torque curve. The good thing also is if you map out your timing curve when you're avoiding knock... this curve very much looks like the inverse of the airmass curve. The result? Well it's another 10.7kw/14hp kw from where I drove it in at. Pretty much everywhere, too. As to how much this car actually makes in Hub Dyno numbers, American Dyno numbers, or Mainline dyno numbers, I say I don't know and it's gone up ~25kw since I started tinkering lol. It IS interesting how the shorter ratio gears I have aren't scaled right on this dyno - 6840RPM is 199KMH, not 175KMH. I have also seen other printouts here with cars with less mods at much higher "kmh" for their RPM due Commodores having 3.45's or longer (!) rear diff ratios maxing out 4th gear which is the 1:1 gear on the T56. Does this matter? No, not really. The real answer is go to the strip and see what it traps, but: I guess I should have gone last Sunday...
×
×
  • Create New...