Jump to content
SAU Community

Recommended Posts

I just got a new Nismo GT LSD installed yesterday and they said to drive it slow for 3-500kms to wear it in. I also was expecting some chattering which i got, but heres the thing. Sometimes/often when driving corners slow or at low speed the thing really thumps i can feel it grabbing and then that force is released and i get some fairly loud thumps. When driving straight its fine and its makes some noise at, say, 40-50kph light cornering. So, this being my first LSD< im wondering

1, is this normal?

2, Will it get less violent over time?

3, Will the noise reduce when it get the NISMO oil changed into it after the run in period (like the bottle says)

4, What were your experiences running in an LSD

thanks

  • Like 1

Did you set it on it's soft setting or leave it on it's 'out of the box' medium setting?

Also if you used the Veruspeed oil that 'should' come with it, it has no friction modifier in it so you may need to stop in to your local performance supplier like rocket industries, performance wholesale or other places like that to pick up a bottle of redline friction modifier. This will help to quieten it down.

I see on pt3 what you said about the oil but it should get the Nismo oil straight out of the box.

It will become less agressive over time but if it's truly annoying, you can adjust the centre from the R/R half shaft. Just drop the R/R (right rear)driveshaft where it meets the half shaft and put your socket (17 or 19mm from memory) into the hole and turn it anti clockwise. That will put it onto it's light setting.

Also, if you didn't do figure 8's in a carpark or whatever for a half hour, it probably hasn't bed in completely yet either

Thanks for the comments so far, and any more suggestions or experience is much appreciated

it came with the Nismo oil but, on advice at the shop, I had them put in Wakos cheaper oil for the bed in stage and then after 500kms they will put in the nismo stuff. Apparently the nismo stuff is meant to have an additive in it that quiets the chattereing, but is this what im experiencing...?

I know that the more expensive GT-PRO LSD has a way to adjust it, but i have the normal non adjust type.

I havent done figure 8s in a car park yet due to no time and very few car park areas to do it (Japan!) but im hoping that just driving it with care, not thrashing it etc will get the job done over time.

I notice the nismo page says( The design standard for the initial torque output value is 8.0 kgf·m at the time of delivery. After the LSD is broken in and the plates are working well together, it will stabilize at 6.0 to 6.5 kgf·m. ) I guess this means it should calm down a little over time?

The diff is 1.5 way, but im just still a bit surprised. Put it this way, its not an annoying sound so much as its a noise that has me a little worried, like it feels like its not quite right, i wince a little sometimes on the slow cornereing. hmmmm

Thanks for the comments so far, and any more suggestions or experience is much appreciated

it came with the Nismo oil but, on advice at the shop, I had them put in Wakos cheaper oil for the bed in stage and then after 500kms they will put in the nismo stuff. Apparently the nismo stuff is meant to have an additive in it that quiets the chattereing, but is this what im experiencing...?

I know that the more expensive GT-PRO LSD has a way to adjust it, but i have the normal non adjust type.

I havent done figure 8s in a car park yet due to no time and very few car park areas to do it (Japan!) but im hoping that just driving it with care, not thrashing it etc will get the job done over time.

I notice the nismo page says( The design standard for the initial torque output value is 8.0 kgf·m at the time of delivery. After the LSD is broken in and the plates are working well together, it will stabilize at 6.0 to 6.5 kgf·m. ) I guess this means it should calm down a little over time?

The diff is 1.5 way, but im just still a bit surprised. Put it this way, its not an annoying sound so much as its a noise that has me a little worried, like it feels like its not quite right, i wince a little sometimes on the slow cornereing. hmmmm

It's normal.

Do the figure 8's. The chatter you are experiencing will quieten down considerably.

Without doing this (as instructed in the Nismo instructions) you will not bed it in correctly. Nismo is a Japanese company, surely they found a place to do figure 8's. Try ringing them to ask where :P

yeah it's normal mate. a tight mech LSD (regardless of 1way, 1.5way or 2way) will give you some nasty noises and bumps and chattering when new and tight and can do even for a long long time. when doing tight slow turns it may feel like the arse end is about to fall out of your car but believe me it's fine. I'm sure the workshop in japan you are using knows what a new LSD is like so if you are really worried get them to drive but my bet is it's completely normal. the reason is they lock up under the slightest throttle application so at low speed tight turns you have one wheel needing to travel a shorter distance than the other but as they are effectively locked together by the diff you either get some tyre chirping (wheel slips on the surface) or the diff locking and unlocking providing the chatter/shudder.

The Nismo diff is noisy irrespective of which setting you have it on. The lowest setting is alot less nasty than the tightest, however. I found that using something other than the fluid provided with the diff does quieten it down a little.

It's normal.

Do the figure 8's. The chatter you are experiencing will quieten down considerably.

Without doing this (as instructed in the Nismo instructions) you will not bed it in correctly. Nismo is a Japanese company, surely they found a place to do figure 8's. Try ringing them to ask where :P

both right and wrong dan :P

nismo reccomend driving in the hills to bed it in, it's the KAAZ diffs that tell you to do the fig 8's ;)

remember to do them in first gear and to have the clutch in on the turns

refer to kaaz website with diagram HERE

i did this procedure and my nismo diff is perfect and has been for years now.

fwiw i change the diff oil with my engine oil (so every 5000 or trackday interval) with motul gear competition 75w150 and it quietens it down every time

It's normal.

Do the figure 8's. The chatter you are experiencing will quieten down considerably.

Without doing this (as instructed in the Nismo instructions) you will not bed it in correctly. Nismo is a Japanese company, surely they found a place to do figure 8's. Try ringing them to ask where :P

lol!

If you do...post the recording of the call

both right and wrong dan :P

nismo reccomend driving in the hills to bed it in, it's the KAAZ diffs that tell you to do the fig 8's ;)

remember to do them in first gear and to have the clutch in on the turns

refer to kaaz website with diagram HERE

i did this procedure and my nismo diff is perfect and has been for years now.

fwiw i change the diff oil with my engine oil (so every 5000 or trackday interval) with motul gear competition 75w150 and it quietens it down every time

Incorrect regarding nismo run in

Nismo State the following

"After Installation, test drive the vehicle for about 180miles (300km) at speed less than 40mph (60kmh). Avoid any quick maneuvers"

http://www.nismo.co.jp/en/products/competition/manual/pdf/lsdpro_manual02.pdf

Incorrect regarding nismo run in

Nismo State the following

"After Installation, test drive the vehicle for about 180miles (300km) at speed less than 40mph (60kmh). Avoid any quick maneuvers"

http://www.nismo.co.jp/en/products/competition/manual/pdf/lsdpro_manual02.pdf

Regardless of what they suggest, it is still correct to run a diff in by doing figure 8's

Regardless of what they suggest, it is still correct to run a diff in by doing figure 8's

this.

my guess is that nismo probably think they have more chance of getting people to actually use their method

I ran it in with 30 mins of figure 8s. man, thats boring. It seemed kinda quieter after that time, as in i could do 8s with almost no chatter, but on normal driving it was still there. I think ultimately its normal and just what i gotta live with

Wait till you drive it in the rain and it understeers into the curb at speed.

Then you will hear all sorts of noises.

I pulled the 2way out of my car due to the lack of turn in it gave it.

A locker is awesome on a really stiff car like a v8 supercar, notice how they jack there wheels to unload one back wheel

Driving it on the street is a major pain in the arse

Wait till you drive it in the rain and it understeers into the curb at speed.

Then you will hear all sorts of noises.

I pulled the 2way out of my car due to the lack of turn in it gave it.

A locker is awesome on a really stiff car like a v8 supercar, notice how they jack there wheels to unload one back wheel

Driving it on the street is a major pain in the arse

your joking right?

I had zero issue with turn in with my nismo 2way lsd in my r33 gts-t, my old man even drove it and had little issue with it.

And regarding the noise issue, Was your install setup correctly? (i mean when it was install in the housing, eg correct backlash etc)

I bought myself a brand new nismo 2way lsd (normal GT type, non-adjustable) install in the housing by a pro, ran the lsd as nismo stated change the oil after the running 300-500km (using the nismo/motul oil) and mine was not very noises at all i was very happy with it

  • 1 year later...

For anyone still reading this, I found Nismo oil to be the best for quietness. It appears to have been made with motul, but in Aus I put in the motul brand oil in and although it chattered less than cheap oil, I will be soon ordering the Redline friction modifier to see if that helps me more, as its still a little too noisy for my liking.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
    • So, now all you need to do is connect the 2 or 3x 12v feeds into the unit to permanent 12v, ACC 12V and IGN 12V that you can find in the spot behind the stereo, and the earth, and then it will switch on with the car.
×
×
  • Create New...