Jump to content
SAU Community

Recommended Posts

It took em a year to send the letter...I got it just before or just after I'd done this years return... Last year I think I did it pretty early, this year I waited a few months coz I couldn't be fked even though it only takes like 20 mins lol

ATO systems are slow to catch out peoples errors but they will catch you lol

ATO systems are getting bigger so there pulling alot of info from institutions on individuals and then data matching.

No one is safe :ninja:

Yep, only did it that year coz the interest was so much...this year it was a lot less so I claimed it...The fact I was already getting a decent return helped

It's still bullshit though, I get done for a couple of hundred while other kunce are out there completely ass f**king the system and getting away with it.

See it all the time at work Dezz. A lot of rich clients get away with a lot of dodgey shit because the accounting companies are afraid to say no otherwise they might lose the client.

A phone call Kris lol You dodgey Kent

Lots of number crunching here...

I washed the R yesterday, went to inspect my 'handiwork' just before and it needs more washing, don't ever ask me to wash your cars.

So I rkn barbs is either

A ) not really on holiday

B ) on holiday alone

C ) a mass loser

I'd say;

D ) all of above.

He is on holidays at home with LA city on wallpaper in his bedroom.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...