Jump to content
SAU Community

Recommended Posts

Sniper fags

Dislike snipers!

knife fights for lols

haha, nah sorry guys, no engineering grad jobs going. Theyve all been filled.

I believe the marketing, sales, engineering and it roles are filled.

You did say "I believe" was just hoping that you believed wrong. :rolleyes:

On another note; pulled up next to a white 86gts. Rego plates "MY-86" signature plates worth $5k

It looked so nice and sounded epic for a stock exhaust. Always loved that boxer exhaust note.

I want one :'(

P plater at my work has one, batman plates [GT 886] lols. And seeing a few more as I drive around these days...

---

Fckn huge ass piece of cardboard came flying from nowhere on bwd hwy and managed to hit car a bit as I was heading to uni... :/

Luckily no scratches or anything I can see...

Ric: yes but only once so can't remember whatever you're going to reference

All those LANS lugging my heavy as f**k pc case around...no wonder I'm so massive

Had like 12 red bulls at shafted in a 24 hour period then almost died driving home

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Did and sync timing with light 
    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
×
×
  • Create New...