Jump to content
SAU Community

Recommended Posts

  • Replies 177
  • Created
  • Last Reply

Top Posters In This Topic

  • 3 weeks later...

All painted and delivered! :D

Also i have a problem, i went to start the car for the first time for about 10 months, Fuel pumps running, it started, idled for about 5 seconds then died, fuel pump keeps running constanly! im thinking the fuel pump is working just not pumping it to the engine ?? Should i hit around the fuel pump, take it out and clean it or simply replace it ? the tank was dead empty for as i said 10-12 months, i have chucked 25 litres into it but still it keeps pumping and car keeps turning over just no start. any help would be great.

Thanks

Adam

409651_10151063841642697_512213490_n.jpg

Edited by adambruv

Could be pump, could be sticky injectors. I would buy a 342 Walbro or Deatschwerks and running a relay for it to run 14v. If you need injectors I have plenty here. Sorry to hear mate but these things happen I guess.

GOOD NEWS! Putting 25 litres of fuel into the tank and letting it sit overnight has done some good! car now starts and runs but fuel pump still runs constanly, will grab dads trade plate and take it for a 10 minute drive to see if it stops, if not ill invest in a new one and see if that makes a difference. Took 2 photo for you, its filthy so once i get it out and washed ill take some better ones.

cheers

1343369477978.jpg

1343369457072.jpg

good news once again!!

I found what the noise was! it was the 4wd pump! that smashed relay i posted on page 3 or 4 is the problem, dad wrigled it around and the 4wd light went off on the dash and the noise stopped :D have to do some more searching to see if i can find a new one, but finnaly everything is nearly finshed on the poor old girl!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • E10 is pretty tightly regulated in percentage. Too much and engines can't adapt. Every incentive is against them to have too little ethanol though. The more ethanol the higher the octane.
    • Yeah i have R34 with factory small box and now RB25DET NEO swapoed and iam planning to upgrade to big box.  So i would be good as long as i do not change diff? 
    • Based off what you’ve said here, I think I’ve figured out a good bit of what I’ve done wrong -  So on the line going from the PCV valve to carbon canister, there’s a T joint that is pretty much right next to that lower port - I hadn’t noticed that the hose in the diagram was curved to attach onto the carb, so I was putting that line for the lower port onto the PCV line / carbon canister line instead. I’m going to have a flick through the manual again tomorrow and should hopefully find a diagram that’ll show me where that T joint should be connected to. Timing also 100% needs to be sorted out as well, should be able to tackle that tomorrow as well. Definitely feel like I should be on the right track now though. 
    • The screw is for idle (pilot circuit) mixture adjustment. Else, I'm confused ~ the diagram shows 2 carby ports, and the intake manifold port, but you're suggesting the "2nd port on the back of the carb that isn’t mentioned in the diagrams" ...yet, both carby ports are shown...que?... ...in any event, that port should be connected, but if not (like it is now), it's unlikely to cause a backfire out the carby (it would introduce false air and give you a fast/lean idle) ...sounds more like timing issues/spark plug wire routing responsible for the backfiring.    
×
×
  • Create New...