Jump to content
SAU Community

Recommended Posts

  • Replies 7.5k
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

lol, yeam ummmmmm thanks to your water pump shitting itself, my car (white stagea) wasnt ready for pickup....... just needs the tune. I thoughtfully pre-shat my waterpump so it was actually replaced yesterday. lol.

damn.

nice gtr by the way.

leaving my car there till friday arvo (wife will have to drive it, nooooooooo); they will rip out the 'cooler piping for me and lip the edges of the piping so it doesnt ever pop off in future, then tune. wont be able to drive for a month tho; kneecap out 7am tomorrow. dang.

spotted a white stagea this morning going up torrens rd, and on the way home spotted a white r33 on salisbury hwy and a silver r33 near my house

If it was early morning like about 7:15ish and somewhere near where churchill rd joins torrens road then that'd be me :P

Just on the way to work :unsure:

Saw a black R32 GTR continuing up main north road at the gepps x intersection. Had a couple stickers on it... I waved to the guys in there (dunno if they saw) and then continued up Port wakefield rd.

-D

If it was early morning like about 7:15ish and somewhere near where churchill rd joins torrens road then that'd be me :domokun:

Just on the way to work :w00t:

it was about 10ish in the morning

also tonight on my way home saw a couple of 32's and 33's

saw 'flirty 2' black or blue r32 on main nth road bout 20 mins ago.

Saw white 33 go past bunnings modbury bout 6ish tonite, sau stickers front and back. Seen it a few times, not sure who it is?

spotted a black 32 gtr at pine av / bonython av roundabout about 1pm this arvo

jeff from TSL drivin thru there in his RB20 R31 bout 2 hours before that

Kye drivin down anzacs near kmart this arvo bout 4 (f**k that rain hey)

and a 32 GTR bein followed by a 32 GTST at morphett / seacombe road roundabout about 6ish

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Did and sync timing with light 
    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
×
×
  • Create New...