Jump to content
SAU Community

Recommended Posts

Well so far it owes me $20 worth of fuel hose and the apple juice itself . Having that Eflex servo closer than the other two seals the deal and fingers crossed more around soon .

My car should go better again with a propper tune and if it has better part throttle torque than now it can probably use a bit more intercooler and turbo .

It still breaks traction in second (pre Eflex and a cold dry morning) but the Mitchy Super Sports are on the water and should help improve traction . If it doesn't will need a better diff center .

First cold start soon , cheers A .

  • Replies 87
  • Created
  • Last Reply

Top Posters In This Topic

Ok first cold start took about threeish seconds to fire and ran well . I got a wiff of the good stuff so must be tossing plenty in .

I have not touched any cold start stuff yet but I'm thinking of increasing the cranking enrichment rather than the actual coolant temp based enrichment .

It was a slightly jerky around 1500 revs but I've altered a few other things which I think will solve that .

This Eflex makes my engine run smoother and idle better than Ultimate 98 did . I've mainly been trying to make it drive nicely at low revs and ATM it pulls smoothly away at 12-1300 revs in 3rd so no complaints there . I'm not sure what timing numers I can input at low revs and light loads so just playing around with this ATM . This car was always a bit touchy at very low revs in 1st and its lightened flywheel doesn't help with slow speeds and taking off . Its much better now and getting better as I muck around with the PFCs settings .

Overall I think going to E85 , well Eflex anyway , is a good step to take because it allows you to get the best out of your current engine with tuning and is far simpler than changing engines . In my case I already had the Z32/PFC/GTR pump/740s in place and getting it to run acceptably with a few corrections has not been real difficult . Andrew pointed out to me that the only easy legal way to get a 30 short block in was to tune for emissions compliance and take that to a willing engineer to certify . I'm going to see how this RB25 goes and I have a feeling I'll outgrow the GTRS and GTt SMIC in the not too distant future . Really the intercooler needs to be upgraded first and then a tune should show how far a GTRS can go on an RB25DET . I have seen some impressive dyno numbers for a GT28 based turbo in the dyno results section - upwards of 270 RWKW though a lot of other things were improved to get it there . Things like headwork Poncams FMICs e85 injectors - and a good exhaust .

A .

yeah the low down torque of e85 is brilliant..my skyline drives like my turbo diesel Ute down low now , which means I don't have to drop it back a gear to get it moving all the time even with a lightweight flywheel

You won't look back disco.. :D

I gave it a bit more cranking fueling for this mornings cold start but I don't think that made much difference . I really have to get the Tech Edge in to see whats going on . Um also need to keep an eye on the fuel filter , don't suppose someone can tell me the Ryco one for an R33 so I can go grab one or two .

After searching I think the std replacement is a Z201 but the larger diameter Z202 from the R31 and 300ZX Turbo may have more filter area .

Cheers A .

Edited by discopotato03

I gave it a bit more cranking fueling for this mornings cold start but I don't think that made much difference . I really have to get the Tech Edge in to see whats going on . Um also need to keep an eye on the fuel filter , don't suppose someone can tell me the Ryco one for an R33 so I can go grab one or two .

After searching I think the std replacement is a Z201 but the larger diameter Z202 from the R31 may have a bit more filter area .

Cheers A .

From personal experience, that "OMG, your filter is gonna clog up with 10 kg worth of shit by the time you drive around the block" is rubbish. I ran mine for 6 months and had a look at it and both filters were clean as.

Actually I mentioned this crud into alky converted cars business to Gary (Sydneykid) and he said provided cars are driven from full tank to almost empty often it shouldn't be a problem . He said many people never run their cars below half a tank but the day they have to go to virtually empty they get a system full of crud .

Anyway they opened the filter on their Lancer and it was clean too . I was planning to run this first tank of Eflex through and then replace the filter which has been there for 19k km .

A .

The sock filters on my Walbro's are black, there is definitely something very fine slowly building up on them over time. I came to the conclusion last year that there must be a slight sediment in the fuel as my fuel system checks out. I have been on e85 for over 3 years now (daily) so any original crud would have been cleaned out surely. From my searches it seems like a common problem in the US, perhaps carbon from some filtering process?

No big deal to change filters every few years though...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Haha, i kow right? Could have bought so many cars for the same amount of money (or less) but driving Unicorn gives you at least +1mln to style 😅. Like wise man said "life's to short to drink cheap wine and drive boring cars" 😉
    • Newbie here, proud owner of an Autech 260RS. I'm on the hunt for wiring diagrams specific to the 260RS, particularly S1. I've ran my eyes through R33, R34 Diagrams, there are some similarities, however continue to find incorrect wire colours and pins on connectors in the 33,34 diagrams.   I was hoping someone could point me in the right direction? I'd be happy to pay for the originals in Japanese. I can translate them, at least they would be accurate.   Any help please would be greatly appreciated, never heard an RB26DETT before let alone driven one, and I've got a spaghetti monster of goodness to sort out.   Cheers Benny  
    • Hey all  im wondering if you can help me please I have put a rb20 box in my r34 gtt as my auto packed up and a friend had a spare box I know it’s not ideal but it will get me up and running for now. we have done the conversation and everything is working great but my Speedo we got a s13 speed sensor but my Speedo reads double now and I bought a speed converter but still not having any luck.  so I thought I’ll reach out and pick your brains  any help would be appreciated please as I wanna drive my car again 
    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
×
×
  • Create New...