Jump to content
SAU Community

Recommended Posts

  • Replies 121
  • Created
  • Last Reply

Top Posters In This Topic

Get some better tyres. Or go and do a defensive driving course, as you will hurt yourself or worse others. You need to learn to drive that thing.

Do a defensive driving course and learn how to control your car ASAP

This

Its funny how everyone is saying how tail happy the Skylines are in the wet, mine was faster and handled better in the wet than it ever did in the dry haha

Haha, drifting around corners is faster

Is it only like this in the wet? Is there a chance that your tyres are on the wrong sides, i.e going against the Correct rotation? Therefore causing water not to dispurse away from the tyres

Taking the swaybars off will actually let the car float around a little more.

I know a few GT-R owners who will drop/loosen the front swaybar if it's really wet at a track day to get more weight moving :thumbsup:

Ahhh I see. I stand corrected.

Is it only like this in the wet? Is there a chance that your tyres are on the wrong sides, i.e going against the Correct rotation? Therefore causing water not to dispurse away from the tyres

That's a really good point.

I remember I borrowed a honda CRV with flogged out suspension all round. If I went around a roundabout any faster than Nanna would, it would understeer into the next lane. So rubbish. I'd be inclined to re-check your suspension geometry, swap out your tyres, and go learn more about driving in the wet. Don't turn under brakes!

if your coilovers are adjustable put it on a looser setting

it's most likely tyre quality/wear causing you to spin out at low speed in the wet

take close up a picture of your tyres on the sidewall & the treads & post it here

I don't understand how a 180 degree spin is possible at such low speeds around a round about. Was it the same round about that you spun out on the second time? Maybe there's a bump in the road that you're not seeing in the wet?

New tires is just a bandage fix imo. I have shitty ones and they grip fine in the, never had it come out unexpectedly, definetly nowhere near a 180. How's it grip in the dry? Could be the Tyres facing the wrong way as mentioned before

It sounds like there's basically no weight transfer at all in your set up.

If your springs & shocks are too stiff; you'll get no warning when it's about to break away.

No body roll is not necessarily a recipe for good handling; there has to be some compliance; otherwise the car won't absorb any bumps, it just bounces over them.

No wheel on the ground; no traction from that wheel. Doesn't matter how wide your tyres are then.

Do the coilovers have adjustable damping? What are the spring rates?

yes they have 30 levels. I figured that its daily driver so i out it on the softest setting on all four corners. could this have something to do with it?

My money is on shit tyres. What are they?

Pedders coilovers arent harder than some jap spec ones. So Im declined to blame that.

My mates 32 had a problem with spinning around spontaneously, but his hicas light was intermittently on. So we blamed that.

But for you, Get some better tyres. Or go and do a defensive driving course, as you will hurt yourself or worse others. You need to learn to drive that thing.

Do you accelerate out of the roundabout when this spin around occurs?

i accelrate , but ever so slightly.

tyres are :

Falken Ziex ZE912

265/35zr18 97w

good tread..

maybe who ever did that threw them over a Nissan Dealer

lol , bakemono racer jab

Do a defensive driving course and learn how to control your car ASAP

yes i will be doing this soon as well

if your coilovers are adjustable put it on a looser setting

it's most likely tyre quality/wear causing you to spin out at low speed in the wet

take close up a picture of your tyres on the sidewall & the treads & post it here

as above , its on its softest setting it its 30range of hardness settings

2012-08-26122020.jpg

2012-08-26122026.jpg

2012-08-26122035.jpg

2012-08-26122008.jpg

2012-08-26121224.jpg

2012-08-26121219.jpg

I don't understand how a 180 degree spin is possible at such low speeds around a round about. Was it the same round about that you spun out on the second time? Maybe there's a bump in the road that you're not seeing in the wet?

no this was a completely different round about

...Was doing about 40km/h.... first thought was I hydroplaned....

You would be surprised how fast you are actually going when you think you are "doing about 40km/h"
I dont feel i have the skills to get myself out of trouble should this happen again with traffic around....

Then get yourself along to a defensive driving course. They should cover wet weather driving, and will even wet the road down for you to show what can happen.
This has only started happening since i got coilovers(which virtually eliminated body roll)...im quite sure that the act that I have a much lower center of gravity has something to do with it but how exactly... whats the physics behind this? I assumed having no body roll was a good thing , but now in the wet I have to take corners slower!

No body roll is bad. The guys at Pedders should know better than to build a setup that doesn't permit lateral weight transfer.

Is the suspension adjustable for ride height? If so, has the car been corner weighted?

What tyre pressures are you running? And a wider tyre doesn't equate to more grip. Maybe the tyres you have aren't really designed for wet road traction.

Have just seen your pics of tyres - nothing wrong with the Falkens. I run them myself, albeit a 235/45x17 on a 32 GTS4 - and I have never had a problem with them in the wet. As I said, maybe they are TOO wide for the rim. And being an 18, there may not be enough compliance in the sidewall to allow good wet grip.

Maybe it was just after a longish dry spell that you struck the roundabout in the wet. Long dry spells cause a buildup of oils and crap that takes quite a bit of rain to disperse. But then you'd expect every second car to be spinning out.

Too stiff

Drive smoothe in bad weather , easy throttle, anticipate braking and idiots cutting you off , and drive to conditions not the speed limit

Tire size is fine same as mine

Oil on roads is likely

Coming into corner to fast and then mid corner snapping throttle closed , unloads the rear end and it snaps it wide on you and your not steering into the skid correctly ends up swapping ends

Bumpy roads ? unload the rear end and your under power flings you sideways , wet road just lubes the spin

Expect all roads to be crap and oily in rain and go to a driving day on a skid pan on car control asap

Edited by Carbon 34

My 2 cents:

  1. Running 265's in the rear and 235's upfront is a significant offset difference for the wheel track. This needs to be compensated for in your driving style. But by the sounds of things you don't have a huge amount of skill.
  2. I think you're running too much negative camber in the rear, the tyres look okay, but I can see more wear on the inside, this means that you do not have the maximum contact patch when cornerning.
  3. When you approach a corner, do you have what is known as "viscious turn in"? I do get a little hardcore on the turn in when I want sideways action, or when I am getting over zealous at the track. Try to be smooth with your steering inputs.
  4. Slow in, fast out. Great words that should be applied to every corner.
  5. Are you taking into account the camber of the road when cornering. Negative effects of camber on corner ability are amplified in the wet.
  6. Wet roads (especially freshly wet roads) are usually very oily as well.

My advice:

  1. Get suspension setup properly
  2. Drop to a 255 rear end, unless you seriously need 265's for traction, don't go any wider than you need to.
  3. Do a defensive driving course, then a track day.
  4. Never ride a motorbike, shit will get ugly in a biblical way

yes they have 30 levels. I figured that its daily driver so i out it on the softest setting on all four corners. could this have something to do with it?

You don't want the softest setting, you want the right setting. If its too soft, it wont control the spring action properly. Try setting it in the middle of the range and drive that way for a couple of weeks, or as long as it takes until you get the feel of it. Then from there try making it harder or softer, but give yourself some time to acclimatise too it. On some shocks with 30 levels it has been found a lot of the settings do nothing... I would try at 15 first, get used to it, then try 10 or 20 or whatever depending on how you think it feels.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Scenic roads, stunning skylines, and Chickos to finish it off! Join SAU NSW as we cruise through the Royal National Park and along Lawrence Hargrave Drive to Figtree! Sunday 26th October 2025 4:30PM Meeting Waterfall Station Parking 5:00PM Cruise Departure Royal National Park > Lawrence Hargrave Dr > Memorial Dr > Sid Parrish Park 6:15PM Arrival at Sid Parrish Park Figtree Meet Location: Waterfall Station Parking Final Destination: Sid Parrish Park RSVP: https://forms.gle/E4s5SiRKQfDdypky8 *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • It's funny, as Ive seen plenty of people use them in cheap builds on YT. And they actually go okay, even though a lot of other maxspeedingrods stuff is terrible. Those turbos seem reliable enough, the only part being, a good quality turbo that is "identical" to it, will out perform it day in and day out. In both a lower boost threshold, and the ability to flow more air at the same boost pressure. As a cheap cheap replacement, not a terrible choice. For cheap and shouldn't blow in a day, not terrible (like other eBay/Temu turbos) for low cost and still decent performance, that's where the question comes in to play from the results I've seen. I'd actually find it hilarious to buy one, and strap it to a paddock basher or some other cheap as POS originally NA car, and send it to the moon!
    • The maxpeedingrods turbo is cheap and bolts on to stock parts. I think you just need a bigger silicone coupler for the intake. Its a cheap china turbo, but it's been running on mine for almost 3 years at 16-19 psi.
    • What do they look like right after you've tried to start it with everything connected? Also post photos of what they actually look like.
    • Also wanted to say, my new spark plugs are blackened looks like it's very rich. I have splitfire coilpacks but stock coilpack loom and ignitor. I tried directly grounding the ignitor ground to body as well. 
×
×
  • Create New...